EQ-IOCON-3 Equinox Technologies, EQ-IOCON-3 Datasheet - Page 38

• Manufacturer Part Number: EQ-IOCON-3
• Description: MOD PPM3 CONN-3 I/O ATMEGA JTAG
• Manufacturer: Equinox Technologies

Specifications of EQ-IOCON-3

• Accessory Type: I/O Connector Module
• For Use With/related Products: PPM3-MK2
• Other names: 483-1005; EQ-IOCON-3

8.0 IO-CON-3 Module (JTAG)
8.1 Overview
This IO-CON module is primarily designed for JTAG ISP of the Atmel ATmega microcontroller family.
It also supports ISP programming via SPI using the 3-wire SPI port + RESET. Supported devices
include the Atmel 89S, AT90S, ATmega and ATtiny devices families. The module features the
Equinox and Atmel 10-way ISP headers plus two ‘Fast connect connectors’ which allow wires to be
manually clipped in. Please refer to Section 3 for a detailed description and pin-out of the 6-way and
10-way ISP headers.
8.2 Features
Please note:
The ‘Atmel AVR JTAG License’ (Order code: PPM3A1-UPG7) is also required to enable the PPM3 to
program Atmel AVR devices via JTAG.
8.3 Support Device Families
This I/O Connection Module supports ISP programming of the following device families using
the low / high voltage SPI programming algorithm:
I/O Connector Modules (IO-CON) for the PPM3 Programming Module – V1.04 – 1
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Plugs into suitable Equinox programmer eg. PPM3 Module
Atmel 10-way JTAG IDC ISP connector (same as JTAG-ICE)
Atmel 6-way IDC ISP Header
Equinox 10-way IDC ISP header
‘Fast Connect’ clip-in connectors for direct wiring to Test Fixture i.e wires from bed-of-nails
probe wires
Screw terminals for power connections
Target Vcc Status LED
Link to connect / isolate the programmer Vcc from the Target Vcc
Atmel AT89S (LV SPI)
Atmel AT90S (LV SPI)
Atmel ATtiny (LV SPI)
Atmel ATtiny (High Voltage)
Atmel ATmega (LV SPI)
Atmel 90CAN (LV SPI)
Atmel 90CAN (JTAG)
Atmel 90USB (LV SPI)
Atmel 90USB (JTAG)
Atmel 90PWM (LV SPI)
Atmel ATmega PICO (LV SPI)
Atmel ATmega PICO (JTAG)
Zensys ZW (LV SPI)
st
April 2008
35