EQ-IOCON-3 Equinox Technologies, EQ-IOCON-3 Datasheet - Page 31

• Manufacturer Part Number: EQ-IOCON-3
• Description: MOD PPM3 CONN-3 I/O ATMEGA JTAG
• Manufacturer: Equinox Technologies

Specifications of EQ-IOCON-3

• Accessory Type: I/O Connector Module
• For Use With/related Products: PPM3-MK2
• Other names: 483-1005; EQ-IOCON-3

6.0 IO-CON-1 Module
6.1 Overview
This IO-CON module is designed for use with any Atmel microcontroller which can be programmed
via the 3-wire SPI port + RESET. Supported devices include the Atmel 89S, AT90S, ATmega and
ATtiny devices families. The module features the Equinox and Atmel 10-way ISP headers plus two
‘Fast connect connectors’ which allow wires to be manually clipped in. Please refer to Section 3 for a
detailed description and pin-out of the 6-way and 10-way ISP headers.
6.2 Features
6.3 Support Device Families
This I/O Connection Module supports ISP programming of the following device families:
Low / High Voltage SPI programming algorithm:
I2C Serial EEPROM programming algorithm:
UART – Boot Loader’ algorithm:
28
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Plugs into suitable Equinox programmer eg. PPM3 Module
Atmel 10-way IDC ISP Header
Atmel 6-way IDC ISP Header
Equinox 10-way IDC ISP header
‘Fast Connect’ clip-in connectors for direct wiring to Test Fixture i.e wires from bed-of-nails
probe wires
Screw terminals for power connections
Target Vcc Status LED
Link to connect / isolate the programmer Vcc from the Target Vcc
Atmel AT89S (LV SPI)
Atmel AT90S (LV SPI)
Atmel ATtiny (LV SPI)
Atmel ATtiny (High Voltage)
Atmel ATmega (LV SPI)
Atmel 90CAN (LV SPI)
Atmel 90USB (LV SPI)
Atmel 90PWM (LV SPI)
Atmel ATmega PICO (LV SPI)
Zensys ZW (LV SPI)
Atmel AT24C
Atmel AT24HC
Atmel AT34C
Atmel T89C51Rx2 (UART – Boot Loader)
Philips P89C51Rx2 (UART – Boot Loader)
Philips P89C66x (UART – Boot Loader)
I/O Connector Modules (IO-CON) for the PPM3 Programming Module – V1.04 – 1
st
April 2008