MTC600-48RR16S9J Emerson Network Power, MTC600-48RR16S9J Datasheet - Page 6

• Manufacturer Part Number: MTC600-48RR16S9J
• Description: MODULE POWER 600W 48VIN 16CH
• Manufacturer: Emerson Network Power
• Series: MTC600r
• Type: Isolatedr

Specifications of MTC600-48RR16S9J

• Output: 3.3V, 12.95V
• Number Of Outputs: 2
• Power (watts): 600W
• Mounting Type: Rack Mount
• Voltage - Input: 48V
• Package / Case: Module
• 1st Output: 12.95 VDC @ 7.6A
• 2nd Output: 3.3 VDC @ 250mA
• Size / Dimension: 7.37" L x 2.34" W x 2.89" H (187.2mm x 59.44mm x 73.4mm)
• Power (watts) - Rated: 600W
• Operating Temperature: -5°C ~ 45°C
• Approvals: CSA, CUL, UL, VDE
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• 3rd Output: -
• 4th Output: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 454-1307

Electrical Specifications (continued)
Output - All Models (continued)
General
Turn-on Time
Early Power
Normal Power
Autonomous Operation
Diagnostic Mode
Redundancy
Hot-Swap Operation
(controlled)
Hot-Swap Operation
(uncontrolled)
Power Module Failover
Fault Isolation
Note 7: All specifi cations in the redundancy sub-section assume the system is populated with Power Modules with the same
manufacturer's model numbers or otherwise compatible Power Modules. At the time of print, PICMG does not have a formal
methodology for verifying compatibility.
7
[GA2,GA1,GA0] = 101, or
[GA2,GA1,GA0] = 110
4 seconds maximum
LED1 displays yellow
Supported
Supported
Supported
Supported
Supported
Supported
Supported
Supported
PM supports Normal Power requirements refer-
within specified voltage magnitude and timing
autonomous outputs to reach regulation band
enced in MicroTCA.0 Rev 1.0 Section 4.4.11.1
enced in MicroTCA.0 Rev 1.0 Section 4.4.11.2
PM supports Autonomous Operation require-
In Diagnostic Mode PM disables the IPMI con-
is capable of accepting the load of a failed PM
PM supports Early Power requirements refer-
When configured as a redundant PM, the PM
trols and slots are powered up based only on
Removal or addition of a PM will not cause a
Removal or addition of a PM will not cause a
ments referenced in MicroTCA.0 Rev 1.0
After power-on of the PM, the time for
Embedded Power for
Business-Critical Continuity
fault or out-of-regulation condition
fault or out-of-regulation condition
A fault in one PM will not cause the
shutdown of another PM
Section 4.4.11.3
PSI# signals
parameters
MTC600 Series
Rev. 05.26.08
6 of 19