GP485A TDK Corporation, GP485A Datasheet - Page 28

• Manufacturer Part Number: GP485A
• Description: GPIB CONTROLLER
• Manufacturer: TDK Corporation
• Series: ZUPr

Specifications of GP485A

• Accessory Type: Controller
• For Use With/related Products: ZUP Series
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: Q4846340

6.1
This chapter contains maintenance information for the GP485 model.
6.2 UNITS UNDER WARRANTY
6.3 PERIODIC MAINTENANCE
6.4 ADJUSTMENT AND CALIBRATION
6.5 PART REPLACEMENT AND REPAIRS
Units requiring repair during the warranty period should be returned to a Nemic-Lambda authorized
service facility. Refer to the address listing on the back cover of this user’s manual. Unauthorized
repairs performed by other than authorized service facilities may void the warranty.
No routine maintenance of the GP485 is required except for periodic cleaning. To clean, disconnect the
unit from the AC supply and allow 30sec for discharging internal voltage. The front panel and the metal
surfaces should be cleaned using a dry cloth. Use low pressure compressed air to blow dust from the
unit.
No internal adjustment or calibration are required. Units that are returned for service will be calibrated
at the service facility. There is NO REASON to open the GP485 cover.
As repairs are made only by the manufacturer of authorized service facilities, no part replacement
information will be discussed here. In case of failure, unusual or erratic operation of the unit, contact a
Nemic-Lambda sales or service facility nearest you. Please refer to the Nemic-Lambda sales offices
listed on the back cover of this user’s manual.
6.6 FUSE RATINGS
Littelfuse Inc. type 215 series: rated 250V 2A.
CHAPTER 6 MAINTENANCE
INTRODUCTION