S8TS-06024-E1. Omron, S8TS-06024-E1. Datasheet - Page 12

• Manufacturer Part Number: S8TS-06024-E1.
• Description: BLOCK BASIC 24V 2.5A SCREW TERM
• Manufacturer: Omron
• Series: S8TSr

Specifications of S8TS-06024-E1.

• Voltage - Output: 24V
• Number Of Outputs: 1
• Power (watts): 60W
• Applications: Commercial
• Power Supply Type: Switching (Closed Frame)
• Voltage - Input: 100 ~ 240VAC
• Mounting Type: DIN Rail
• 1st Output: 24 VDC @ 2.5A
• Size / Dimension: 4.72" L x 1.69" W x 4.72" H (120mm x 43mm x 120mm)
• Power (watts) - Rated: 60W
• Operating Temperature: -10°C ~ 50°C
• Efficiency: 75%
• Approvals: CE, cUL, cUR, UL, VDE
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• 3rd Output: -
• 2nd Output: -
• 4th Output: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: S8TS06024E1

■ Charging Batteries
If a battery is connected as the load, provide an overcurrent control
circuit and an overvoltage protective circuit.
■ Output Voltage Adjuster (V.ADJ)
Do not exert excessive force on the output voltage adjuster (V.ADJ).
Doing so may break the adjuster.
Setting the adjuster to a setting less than 10% may cause the under-
voltage detection function to operate.
■ Bus Line Connectors
Do not apply sudden shocks (e.g., by dropping) to the Bus Line Con-
nectors. Doing so may result in damage.
■ DIN Track Mounting
To mount the Block on a DIN track, hook portion (A) of the Block onto
the track and press the Block in direction (B).
To dismount the Block, pull down portion (C) with a flat-blade screw-
driver and pull out the Block.
■ No Output Voltage
If there is no output voltage, it is possible that overcurrent protection
or overvoltage protection is operating. It is also possible that the latch
protection circuit is operating due to the application of a large surge,
such as lightning surge. Confirm the 2 points below. If there is still no
output voltage, consult your OMRON representative.
• Checking for Overcurrent Protection:
• Checking for Overvoltage Protection or Latch Protection:
12
Separate the load line and confirm that it is not in an overcurrent
state (including short-circuits).
Turn the input power supply OFF, and then turn it ON again after 1
minute or more has elapsed.
C
Track stopper
Switching Power Supply
B
A
30 mm min.
S8TS