SPDC12L00010 STMicroelectronics, SPDC12L00010 Datasheet - Page 20

• Manufacturer Part Number: SPDC12L00010
• Description: IC BUCK ADJ 10A 121LGA
• Manufacturer: STMicroelectronics
• Type: Point of Load (POL) Non-Isolated with UVLOr

Specifications of SPDC12L00010

• Output: 0.6 ~ 5V
• Number Of Outputs: 1
• Power (watts): 50W
• Mounting Type: Surface Mount
• Voltage - Input: 1.8 ~ 14V
• Package / Case: 121-LGA
• 1st Output: 0.6 ~ 5 VDC @ 10A
• Size / Dimension: 0.59" L x 0.59" W x 0.11" H (15mm x 15mm x 2.8mm)
• Power (watts) - Rated: 50W
• Operating Temperature: -40°C ~ 85°C
• Efficiency: 93%
• Current - Output: 10A
• Voltage - Output: 0.6 ~ 5 V
• Frequency - Switching: 729kHz
• Synchronous Rectifier: No
• Output Voltage: 0.6 V to 5 V
• Output Current: 0 A to 10 A
• Input Voltage: 1.8 V to 14 V
• Supply Current: 65 mA
• Switching Frequency: 729 KHz
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 40 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• 3rd Output: -
• 2nd Output: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 497-9072

Application information
5.9
5.10
5.11
20/29
Undervoltage lock out
Connecting a proper resistor (see par.
is possible to select two different thresholds for UVLO:
4.2 V/3.8 V for 5 V input range;
8.6 V/7.7 V for 12 V input range.
Program setting
Connecting a resistor from PRG (pin L7) to VAUX (pin J11), it is possible to select different
operation modes, according to the following table:
Table 12.
Voltage sensing
Using VSENSE (pin L2) it is possible to recover the voltage drop on VOUT PCB track.
Connect VSENSE in a point closed to the load (see
Using VSENSE connection, it will not recover the voltage drop on PGND PCB track.
Leaving VSENSE floating, the output voltage will be sensed at VOUT (bank 3) but its value
will be affected by an error, due to an internal resistor connected between VSENSE and
VOUT.
This error can reach +4.7%, depending on output voltage value, therefore it is advisable to
use VSENSE pin.
6.2 k Ω
4.3 k Ω
2.7 k Ω
1.8 k Ω
1.2 k Ω
11 k Ω
R
n.c.
0 Ω
PRG
Program setting
12 V range
5 V range
UVLO.
Doc ID 15103 Rev 3
Section 5.10
Not latched
Not latched
Not latched
Not latched
) from PRG (pin L7) to VAUX (pin J11), it
Latched
Latched
Latched
Latched
Figure
OVP
6).
Sink-mode
SPDC12L00010
Not
Yes
Not
Yes
Not
Yes
Not
Yes