M0116MY-161LSBR2-1 Newhaven Display, M0116MY-161LSBR2-1 Datasheet - Page 11

• Manufacturer Part Number: M0116MY-161LSBR2-1
• Description: MODULE VF CHAR 1X16 11.1MM
• Manufacturer: Newhaven Display

Specifications of M0116MY-161LSBR2-1

• Outline L X W X H: 177.30mm x 32.00mm x 15.00mm
• Viewing Area: 132.50mm L x 11.00mm W
• Display Format: 16 x 1
• Display Type: Character
• Voltage - Supply: 4.5 V ~ 5.5 V
• Character Size: 10.00mm H x 5.00mm W
• Interface: Serial
• Operating Temperature: 0°C ~ 70°C
• Product: Character Display Modules
• Character Count X Line: 16 x 1
• Module Size (w X H X T): 177.3 mm x 32 mm x 15 mm
• Voltage Rating: 4.5 V to 5.5 V
• Operating Temperature Range: 0 C to + 70 C
• Viewing Area (w X H): 132.5 mm x 11 mm
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Number Of Dots: -
• Format: -
• Lead Free Status / Rohs Status: Details

6. OPERATING RECOMMENDATIONS
NOTE: Newhaven Display reserves the right to change or modify this existing specification and or product in
order to improve the quality of this design.
6.1 Avoid applying excessive shock or vibration beyond the specification for the VFD module.
6.2 Since VFD is made of glass material, careful handling is required.
6.3 When mounting the VFD module to your system, leave a slight gap between the VFD glass and your front panel.
6.4 Avoid plugging or unplugging the interface connection with the power on, otherwise it may cause
6.5 Slow starting power supply may cause non-operation because one chip Mi-com won’t be reset.
6.6 Exceeding any of maximum ratings may cause the permanent damage.
6.7 Since the VFD module contain high voltage source, careful handling is required while power is on.
6.8 When the power is turned off, the capacitor does not discharge immediately.
6.9 The power supply must be capable of providing at least 3 times the rated current, because the surge current
6.10 Avoid using the module where excessive noise interference is expected.
6.11 Since all VFD modules contain C-MOS ICs, anti-static handling procedures are always required.
TNDARD
In other words, short-circuit of mounted components on PCB within 30 seconds after power-off may
cause damage to the module.
The module should be mounted without stress to avoid flexing of the PCB.
severe damage to input circuitry.
So the high voltage applied to the VFD must not get in contact with ICs.
may be 3 times the specified current consumption when the power is turned on.
Noise may affect the interface signal and cause improper operation. It is important to keep the length of the
interface cable less than 50cm.
NAME
SPECIFICATION FOR APPROVAL
DOCUMENT NO.
REV.NO
1.0
PAGE
10/10