LM5025AMTC/NOPB National Semiconductor, LM5025AMTC/NOPB Datasheet - Page 13

• Manufacturer Part Number: LM5025AMTC/NOPB
• Description: IC CTRLR PWM CLAMP VOLT 16TSSOP
• Manufacturer: National Semiconductor
• Series: PowerWise®r

Specifications of LM5025AMTC/NOPB

• Pwm Type: Voltage Mode
• Number Of Outputs: 2
• Frequency - Max: 1MHz
• Duty Cycle: 92.5%
• Voltage - Supply: 13 V ~ 90 V
• Buck: Yes
• Boost: Yes
• Flyback: Yes
• Inverting: Yes
• Doubler: No
• Divider: No
• Cuk: No
• Isolated: Yes
• Operating Temperature: -40°C ~ 125°C
• Package / Case: 16-TSSOP
• Frequency-max: 1MHz
• Number Of Pwm Outputs: 2
• On/off Pin: No
• Adjustable Output: No
• Topology: Forward
• Switching Freq: 220KHz
• Output Current: 3000/1000A
• Synchronous Pin: Yes
• Rise Time: 20ns
• Fall Time: 15ns
• Operating Temperature Classification: Automotive
• Mounting: Surface Mount
• Pin Count: 16
• Package Type: TSSOP
• For Use With: LM5025AEVAL - BOARD EVALUATION LM5025ALM5025EVAL - EVALUATION BOARD FOR LM5025
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: *LM5025AMTC; *LM5025AMTC/NOPB; LM5025AMTC

Soft-start
The softstart feature allows the power converter to gradually
reach the initial steady state operating point, thus reducing
start-up stresses and surges. At power on, a 20µA current is
sourced out of the softstart pin (SS) into an external capaci-
tor. The capacitor voltage will ramp up slowly and will limit
the COMP pin voltage and therefore the PWM duty cycle. In
the event of a fault as determined by V
undervoltage (UVLO) or second level current limit, the output
gate drivers are disabled and the softstart capacitor is fully
discharged. When the fault condition is no longer present a
softstart sequence will be initiated. Following a second level
current limit detection (CS2), the softstart current source is
reduced to 1µA until the first output pulse is generated by the
PWM comparator. The current source returns to the nominal
20µA level after the first output pulse ( ~ 1V at the SS pin).
CC
undervoltage, line
13
Thermal Protection
Internal Thermal Shutdown circuitry is provided to protect the
integrated circuit in the event the maximum junction tem-
perature is exceeded. When activated, typically at 165˚C,
the controller is forced into a low power standby state with
the output drivers and the bias regulator disabled. The de-
vice will restart after the thermal hysteresis (typically 25˚C).
During a restart after thermal shutdown, the softstart capaci-
tor will be fully discharged and then charged in the low
current mode (1µA) similar to a second level current limit
event. The thermal protection feature is provided to prevent
catastrophic failures from accidental device overheating.
www.national.com