L6599ATD STMicroelectronics, L6599ATD Datasheet - Page 15

• Manufacturer Part Number: L6599ATD
• Description: IC RESONANT CONVRTR CTRLR 16SOIC
• Manufacturer: STMicroelectronics

Specifications of L6599ATD

• Applications: Resonant Converter Controller
• Voltage - Supply: 8.85 V ~ 16 V
• Current - Supply: 3.5mA
• Operating Temperature: -40°C ~ 125°C
• Mounting Type: Surface Mount
• Package / Case: 16-SOIC (3.9mm Width)
• Number Of Outputs: Single Output
• Output Voltage: 13.3 V
• Switching Frequency: 200 KHz
• Duty Cycle (max): 52 %
• Operating Supply Voltage: 8.85 V to 16 V
• Supply Current: 3.5 mA
• Maximum Operating Temperature: + 150 C
• Minimum Operating Temperature: - 40 C
• Fall Time: 30 ns
• Mounting Style: SMD/SMT
• Rise Time: 60 ns
• For Use With: 497-10542 - BOARD EVAL BASED ON L6599
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Voltage - Input: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

L6599AT
6.2
Figure 6.
In
signal, as well as the swinging node of the half-bridge leg (HB) is shown. Note that the low-
side gate-drive is turned on while the oscillator's triangle is ramping up and the high-side
gate-drive is turned on while the triangle is ramping down. In this way, at start-up, or as the
IC resumes switching during burst-mode operation, the low-side MOSFET is switched on
first to charge the bootstrap capacitor. As a result, the bootstrap capacitor is always charged
and ready to supply the high-side floating driver.
Operation at no load or very light load
When the resonant half-bridge is lightly loaded or not loaded at all, its switching frequency is
at its maximum value. To keep the output voltage under control in these conditions and to
avoid losing soft-switching, there must be some significant residual current flowing through
the transformer's magnetizing inductance. This current, however, produces some
associated losses that prevent converter's no-load consumption from achieving very low
values.
To overcome this issue, the L6599AT enables the designer to make the converter operate
intermittently (burst-mode operation), with a series of a few switching cycles spaced out by
long idle periods where both MOSFETs are in OFF-state, so that the average switching
frequency can be substantially reduced. As a result, the average value of the residual
magnetizing current and the associated losses is considerably cut down, thus facilitating the
converter to comply with energy saving recommendations.
The L6599AT can be operated in burst-mode by using pin 5 (STBY): if the voltage applied to
this pin falls below 1.24 V the IC enters an idle state where both gate-drive outputs are low,
the oscillator is stopped, the soft-start capacitor CSS keeps its charge and only the 2 V
reference at RF
discharge. The IC resumes normal operation as the voltage on the pin exceeds 1.24 V by 50
mV.
To implement burst-mode operation the voltage applied to the STBY pin needs to be related
to the feedback loop.
input voltage range (e.g. when there is a PFC front-end).
Figure 6
the timing relationship between the oscillator waveform and the gate-drive
Oscillator waveforms and their relationship with gate-driving signals
min
pin stays alive to minimize the IC's consumption and the V
Figure 7
a shows the simplest implementation, suitable for a narrow
Doc ID 15534 Rev 3
Application information
CC
capacitor's
15/31