LP3906SQ-PPXP/NOPB National Semiconductor, LP3906SQ-PPXP/NOPB Datasheet - Page 18

• Manufacturer Part Number: LP3906SQ-PPXP/NOPB
• Description: IC REG DC-DC/LINEAR DUAL 24-LLP
• Manufacturer: National Semiconductor
• Series: PowerWise®r

Specifications of LP3906SQ-PPXP/NOPB

• Applications: Digital Cores
• Current - Supply: 60µA
• Voltage - Supply: 2.7 V ~ 5.5 V
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 24-LLP
• For Use With: LP3906SQ-JXXIEV - BOARD EVALUATION LP3906SQ-JXXI
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: LP3906SQ-PPXPTR

www.national.com
POWER ON
EN_T assertion causes the LP3906 to emerge from Standby
mode to Full Operation mode at a preset timing sequence. By
default, the enables for the LDOs and Bucks are internally
pulled up, which causes the part to turn ON automatically. If
the user wishes to have a preset timing sequence to power
on the regulators, the external regulator enables must be tied
LOW. Otherwise, simply tie the enables of each specific reg-
ulator HIGH.
EN_T is edge triggered with rising edge signaling the chip to
power on. The EN_T input is deglitched and the default is set
at 1 ms. As shown in the next 2 diagrams, a rising EN_T edge
will start a power on sequence, while a falling EN_T edge will
start a shutdown sequence. If EN_T is high, toggling the ex-
ternal enables of the regulators will have no effect on the chip.
Note: LP3906 The default Power on delays can be reprogrammed at final
t
1
test or by using I
1.5
(ms)
Default Power ON Sequence:
2
t
C registers to 1, 1.5, 2, 3, 6, or 11 ms.
2
2.0
(ms)
t
3
(ms)
3
t
4
(ms)
6
18
The regulators can also be programmed through I
on and off. By default, the I
ON.
The regulators are on following the pattern below:
Regulators on = (I
EN_T high).
2
C enable) AND (External pin enable OR
2
C enables for the regulators are
2
C to turn
20197809