VNH3SP30TR-E STMicroelectronics, VNH3SP30TR-E Datasheet - Page 20

• Manufacturer Part Number: VNH3SP30TR-E
• Description: IC DRIVER MOTOR H-BRIDGE 30-MPSO
• Manufacturer: STMicroelectronics
• Type: H-Bridge Motor Driverr

Specifications of VNH3SP30TR-E

• Applications: Automotive
• Number Of Outputs: 2
• Current - Output: 30A
• Voltage - Supply: 5.5 V ~ 36 V
• Operating Temperature: -40°C ~ 150°C
• Mounting Type: Surface Mount
• Package / Case: 30-MPSO, MultiPowerSO
• Logic Family: VNH3SP30TR-E
• Logic Type: H-Bridge Motor Driver
• Supply Voltage (max): 40 V
• Supply Voltage (min): - 0.3 V
• Maximum Operating Temperature: + 150 C
• Mounting Style: SMD/SMT
• Minimum Operating Temperature: - 40 C
• Supply Current: 15 mA
• Operating Current: 15mA
• Operating Temperature Classification: Automotive
• Package Type: MultiPowerSO
• Operating Supply Voltage (min): 5.5V
• Operating Supply Voltage (max): 36V
• Motor Type: Half Bridge
• No. Of Outputs: 2
• Output Current: 30A
• Supply Voltage Range: 5.5V To 36V
• Driver Case Style: SOIC
• No. Of Pins: 30
• Operating Temperature Range: -40°C To +150°C
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Voltage - Load: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 497-3565-2; VNH3SP30-E; VNH3SP3013TR

Application information
3
Note:
20/33
Application information
In normal operating conditions the DIAG
device. This pin must be externally pulled high.
PWM pin usage: In all cases, a “0” on the PWM pin will turn off both LS
When PWM rises back to “1”, LS
Figure 33. Typical application circuit for DC to 10 kHz PWM operation short circuit
The value of the blocking capacitor (C) depends on the application conditions and defines voltage and
current ripple onto supply line at PWM operation. Stored energy of the motor inductance may fly back
into the blocking capacitor, if the bridge driver goes into tri-state. This causes a hazardous overvoltage
if the capacitor is not big enough. As basic orientation, 500µF per 10A load current is recommended.
In case of a fault condition the DIAG
The fault conditions are:
●
●
overtemperature on one or both high sides
short to battery condition on the output (saturation detection on the low side power
MOSFET)
µC
protection
A
or LS
X
/EN
B
X
X
/EN
turn on again depending on the input pin state.
pin is considered as an output pin by the device.
X
pin is considered as an input pin by the
A
and LS
VNH3SP30-E
B
switches.