LM3402HVMR/NOPB National Semiconductor, LM3402HVMR/NOPB Datasheet - Page 21

• Manufacturer Part Number: LM3402HVMR/NOPB
• Description: IC LED DRVR HP CONST CURR 8-PSOP
• Manufacturer: National Semiconductor
• Series: PowerWise®r
• Type: High Power, Constant Currentr

Specifications of LM3402HVMR/NOPB

• Constant Current: Yes
• Topology: PWM, Step-Down (Buck)
• Number Of Outputs: 1
• Internal Driver: Yes
• Type - Primary: Automotive
• Type - Secondary: High Brightness LED (HBLED), White LED
• Frequency: 1MHz
• Voltage - Supply: 6 V ~ 75 V
• Mounting Type: Surface Mount
• Package / Case: 8-PSOP
• Operating Temperature: -40°C ~ 125°C
• Current - Output / Channel: 500mA
• Internal Switch(s): Yes
• Efficiency: 96%
• Primary Input Voltage: 75V
• No. Of Outputs: 1
• Output Voltage: 73V
• Output Current: 500mA
• Voltage Regulator Case Style: PSOP
• No. Of Pins: 8
• Operating Temperature Range: -40°C To +125°C
• Svhc: No SVHC (15-Dec-2010)
• Rohs Compliant: Yes
• For Use With: 551600000-001A/NOPB - BOARD WEBENCH SO8/SOP LM3404/2551600003-001A - BOARD WEBENCH MSOP LM3402LM3402HVEVAL - BOARD EVALUATION FOR LM3402HV
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Voltage - Output: -
• Other names: LM3402HVMR

less risk of injecting noise into other circuits. The path be-
tween the input source and the input capacitor and the path
between the recirculating diode and the LEDs/current sense
resistor are examples of continuous current paths. In contrast,
the path between the recirculating diode and the input capac-
itor carries a large pulsating current. This path should be
routed with a short, thick shape, preferably on the component
side of the PCB. Multiple vias in parallel should be used right
at the pad of the input capacitor to connect the component
side shapes to the ground plane. A second pulsating current
loop that is often ignored is the gate drive loop formed by the
SW and BOOT pins and capacitor CB. To minimize this loop
at the EMI it generates, keep CB close to the SW and BOOT
pins.
CURRENT SENSING
The CS pin is a high-impedance input, and the loop created
by R
SNS
, R
Z
(if used), the CS pin and ground should be made
21
as small as possible to maximize noise rejection. R
therefore be placed as close as possible to the CS and GND
pins of the IC.
REMOTE LED ARRAYS
In some applications the LED or LED array can be far away
(several inches or more) from the LM3402/02HV, or on a sep-
arate PCB connected by a wiring harness. When an output
capacitor is used and the LED array is large or separated from
the rest of the converter, the output capacitor should be
placed close to the LEDs to reduce the effects of parasitic
inductance on the AC impedance of the capacitor. The current
sense resistor should remain on the same PCB, close to the
LM3402/02HV.
www.national.com
SNS
should