STP08DP05TTR STMicroelectronics, STP08DP05TTR Datasheet - Page 19

• Manufacturer Part Number: STP08DP05TTR
• Description: IC LED DRIVER LINEAR 16-TSSOP
• Manufacturer: STMicroelectronics
• Type: Linear (Serial Interface)r

Specifications of STP08DP05TTR

• Constant Current: Yes
• Topology: 8-Bit Shift Register
• Number Of Outputs: 8
• Internal Driver: Yes
• Type - Primary: General Purpose
• Frequency: 30MHz
• Voltage - Supply: 3 V ~ 5.5 V
• Voltage - Output: 20V
• Mounting Type: Surface Mount
• Package / Case: 16-TSSOP
• Operating Temperature: -40°C ~ 125°C
• Current - Output / Channel: 100mA
• Internal Switch(s): Yes
• Low Level Output Current: - 1 mA
• High Level Output Current: 1 mA
• Operating Supply Voltage: 3 V to 3.6 V
• Maximum Supply Current: 13.5 mA
• Maximum Operating Temperature: + 125 C
• Mounting Style: SMD/SMT
• Minimum Operating Temperature: - 40 C
• Led Driver Application: LED Displays
• No. Of Outputs: 8
• Output Current: 100mA
• Output Voltage: 20V
• Input Voltage: 3V To 5.5V
• For Use With: 497-6338 - BOARD EVAL HB 40LED STP08DP05497-6337 - BOARD EVAL HB 40LED STP08DP05
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Efficiency: -
• Lead Free Status / Rohs Status: Details
• Other names: 497-6029-2

STP08DP05
10.2
Figure 18. Detection diagram
Phase two: “error detection“
The eight data bits must be set “1” in order to set ON all the outputs during the detection.
The data are latched by LE/DM1 and after that the outputs are ready for the detection
process. When the micro controller switches the OE/DM2 to LOW, the device drives the
LEDs in order to analyze if an OPEN or SHORT condition has occurred.
The LEDs status will be detected at least in 1 microsecond and after this time the
microcontroller sets OE\DM2 in HIGH state and the output data detection result will go to
the microprocessor via SDO.
Detection mode and normal mode use both the same format data. As soon as all the
detection data bits are available on the serial line, the device may go back to normal mode
of operation. To re-detect the status the device must go back in normal mode and re-
entering in error detection mode.
Doc ID 13405 Rev 4
Detection mode functionality
19/30