LM234Z STMicroelectronics, LM234Z Datasheet - Page 7

• Manufacturer Part Number: LM234Z
• Description: IC CURRENT SOURCE 3% TO92-3
• Manufacturer: STMicroelectronics

Specifications of LM234Z

• Function: Current Source
• Accuracy: ±3%
• Voltage - Input: 1 ~ 40 V
• Current - Output: 10mA
• Operating Temperature: -25°C ~ 100°C
• Mounting Type: Through Hole
• Package / Case: TO-92-3 (Standard Body), TO-226
• Full Temp Accuracy: 3 C
• Supply Voltage (max): 10 V
• Supply Voltage (min): 1 V
• Maximum Operating Temperature: + 100 C
• Minimum Operating Temperature: - 25 C
• Supply Current: 10 mA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Sensing Method: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

LM134-LM234-LM334
4.6
Sensing temperature
The LM134, LM234, LM334 are excellent remote controlled temperature sensors because
their operation as current sources preserves their accuracy even in the case of long
connecting wires. The output current is directly proportional to the absolute temperature in
Kelvin degrees according to the following equation.
The calibration of the LM134, LM234, LM334 is simplified by the fact that most of the initial
accuracy is due to gain limitation (slope error) and not an offset. Gain adjustment is a one
point trim because the output of the device extrapolates to zero at 0°K.
Figure 10. Device calibration
This particularity of the LM134, LM234, LM334 is illustrated in the above diagram. Line abc
represents the sensor current before adjustment and line a’b’c’ represents the desired
output. A gain adjustment provided at T2 will move the output from b to b’ and will correct
the slope at the same time so that the output at T1 and T3 will be correct. This gain
adjustment can be carried out by means of R
adjustment, the slope error should be less than 1%. A low temperature coefficient for R
necessary to keep this accuracy. A 33ppm/°C temperature drift of R
1% on the slope because the resistance follows the same temperature variations as the
LM134, LM234, LM334.
Three wires are required to isolate R
is not recommended, metal-film resistors with a drift of less than 20ppm/°C are now
available. Wirewound resistors can be used when very high stability is required.
I
set
set
=
from the LM134, LM234, LM334. Since this solution
(
---------------------------------------- -
227µV/°K) (T
set
R
set
or the load resistor used in the circuit. After
)
Application information
set
will give an error of
set
7/16
is