DS2762BE+025 Maxim Integrated Products, DS2762BE+025 Datasheet - Page 21

• Manufacturer Part Number: DS2762BE+025
• Description: IC MON BATT LI-ION HP 16-TSSOP
• Manufacturer: Maxim Integrated Products

Specifications of DS2762BE+025

• Function: Battery Monitor
• Battery Type: Lithium-Ion (Li-Ion)
• Voltage - Supply: 2.5 V ~ 5.5 V
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 16-TSSOP
• Product: Fuel Gauges
• Operating Supply Voltage: 2.5 V to 5.5 V
• Supply Current: 60 uA
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 40 C
• Charge Safety Timers: Yes
• Mounting Style: SMD/SMT
• Temperature Monitoring: Yes
• Uvlo Start Threshold: 2.6 V
• Uvlo Stop Threshold: 4.35 V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Write Data [6Ch, XX]. This command writes data to the DS2762 starting at memory address XX. The LSb of the
data to be stored at address XX can be written immediately after the MSb of address has been entered. Because
the address is automatically incremented after the MSb of each byte is written, the LSb to be stored at address XX
+ 1 can be written immediately after the MSb to be stored at address XX. If the bus master continues to write
beyond address FFh, the DS2762 ignores the data. Writes to read-only addresses, reserved addresses and locked
EEPROM blocks are ignored. Incomplete bytes are not written. Writes to unlocked EEPROM blocks are to shadow
RAM rather than EEPROM. See the Memory section for more details.
Copy Data [48h, XX]. This command copies the contents of shadow RAM to EEPROM for the 16-byte EEPROM
block containing address XX. Copy data commands that address locked blocks are ignored. While the copy data
command is executing, the EEC bit in the EEPROM register is set to 1 and writes to EEPROM addresses are
ignored. Reads and writes to non-EEPROM addresses can still occur while the copy is in progress. The copy data
command execution time, t
Recall Data [B8h, XX]. This command recalls the contents of the 16-byte EEPROM block containing address XX
to shadow RAM.
Lock [6Ah, XX]. This command locks (write-protects) the 16-byte block of EEPROM memory containing memory
address XX. The LOCK bit in the EEPROM register must be set to l before the lock command is executed. If the
LOCK bit is 0, the lock command has no effect. The lock command is permanent; a locked block can never be
written again.
Table 3. Function Commands
COMMAND
Recall Data
Read Data
Write Data
Copy Data
Lock
Copies shadow RAM data to
Permanently locks the block
EEPROM block containing
Reads data from memory
containing address XX to
Recalls EEPROM block
Writes data to memory
containing address XX
starting at address XX
starting at address XX
EEC
shadow RAM
of EEPROM
FUNCTION
address XX
, is 2ms typical and starts after the last address bit is transmitted.
PROTOCOL
COMMAND
6Ch, XX
B8h, XX
6Ah, XX
69h, XX
48h, XX
21 of 25
COMMAND PROTOCOL
BUS STATE AFTER
Master Rx
Master Tx
Bus idle
Bus idle
Bus idle
Up to 256 bytes of
Up to 256 bytes of
BUS DATA
None
None
None
data
data