W19B320BTT7H Winbond Electronics, W19B320BTT7H Datasheet - Page 11

• Manufacturer Part Number: W19B320BTT7H
• Description: IC FLASH 32MBIT 70NS 48TSOP
• Manufacturer: Winbond Electronics

Specifications of W19B320BTT7H

• Format - Memory: FLASH
• Memory Type: FLASH
• Memory Size: 32M (4Mx8, 2Mx16)
• Speed: 70ns
• Interface: Parallel
• Voltage - Supply: 2.7 V ~ 3.6 V
• Operating Temperature: -20°C ~ 85°C
• Package / Case: 48-TSOP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: W19B320BTT-H; W19B320BTT-H

6.1.7
When the #OE input is at V
impedance state.
6.1.8
The AUTOSELECT mode offers manufacturer and device identification, as well as sector protection
verification, through identifier codes output on DQ0-DQ7. This mode is primarily intended for
programming equipment to automatically match a device to be programmed with its corresponding
programming algorithm. However, the AUTOSELECT codes can also be accessed in-system through
the command register.
When using programming equipment, the AUTOSELECT mode requires V
address pins A9. Address pins A6, A1, and A0 must be as shown in table. In addition, when verifying
sector protection, the sector address must appear on the appropriate highest order address bits.
When all necessary bits have been set as required, the programming equipment may then read the
corresponding identifier code on DQ0-DQ7.
6.1.9
The hardware sector protection feature disables both program and erasure operations in any sectors.
The hardware sector Unprotection feature re-enables both program and erasure operations in
previously protected sectors. Sector Protection/Unprotection can be implemented through two
methods.
The primary method requires V
programming equipment. This method uses standard microprocessor bus cycle timing.
The alternate method intended only for programming equipment requires V
is possible to determine whether a sector is protected or unprotected. See the Application Note for detail
information.
6.1.10 Write Protect (#WP)
The Write Protect function provides a hardware method to protect the certain boot sectors without
using V
When the #WP/ACC pin is set at V
outermost 8 Kbytes boot sectors independently of whether those sectors were protected or
unprotected using the method described in “Sector/Sector Block Protection and Unprotection.” The
two outermost 8 Kbytes boot sectors are the two sectors containing either the lowest addresses in a
bottom-boot-configured device or the highest addresses in a top-boot-configured device.
When the #WP/ACC pin is set at V
were last set either to be protected or unprotected. That is, sector Protection or Unprotection for these
two sectors depends on whether they were last protected or unprotected using the method described
in “Sector/Sector Block Protection and Unprotection”.
Please note that the #WP/ACC pin must not be left floating or unconnected; otherwise, the
inconsistent behavior of the device may occur.
ID
Output Disable Mode
autoselect Mode
Sector/Sector Block Protection and Unprotection
. This function is one of two features provided by the #WP/ACC pin.
IH
, output from the device is disabled. The output pins are set in the high
ID
on the
IH
IL
, the device reverts to the two outermost 8 Kbytes boot sectors
, the device disables program and erase functions in the two
#RESET
pin, and can be implemented either in-system or through
- 11 -
W19B320BT/B DATASHEET
Publication Release Date:Dec. 25, 2007
ID
on address pin A9 and
ID
(8.5V to 11.5V) on
Revisionv A3
#OE.
It