M45PE80-VMP6 NUMONYX, M45PE80-VMP6 Datasheet - Page 23

• Manufacturer Part Number: M45PE80-VMP6
• Description: IC FLASH 8MBIT 25MHZ 8VFQFPN
• Manufacturer: NUMONYX
• Series: Forté™r

Specifications of M45PE80-VMP6

• Format - Memory: FLASH
• Memory Type: FLASH
• Memory Size: 8M (1M x 8)
• Speed: 25MHz
• Interface: SPI, 3-Wire Serial
• Voltage - Supply: 2.7 V ~ 3.6 V
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 8-VFQFN, 8-VFQFPN
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Release from Deep Power-down (RDP)
Once the device has entered the Deep Power-
down mode, all instructions are ignored except the
Release from Deep Power-down (RDP) instruc-
tion. Executing this instruction takes the device out
of the Deep Power-down mode.
The Release from Deep Power-down (RDP) in-
struction is entered by driving Chip Select (S) Low,
followed by the instruction code on Serial Data In-
put (D). Chip Select (S) must be driven Low for the
entire duration of the sequence.
The instruction sequence is shown in
The Release from Deep Power-down (RDP) in-
struction is terminated by driving Chip Select (S)
Figure 19. Release from Deep Power-down (RDP) Instruction Sequence
S
C
D
Q
High Impedance
0
1
2
Instruction
3
4
5
Figure
6
7
19..
Deep Power-down Mode
High. Sending additional clock cycles on Serial
Clock (C), while Chip Select (S) is driven Low,
cause the instruction to be rejected, and not exe-
cuted.
After Chip Select (S) has been driven High, fol-
lowed by a delay, t
Standby mode. Chip Select (S) must remain High
at least until this period is over. The device waits
to be selected, so that it can receive, decode and
execute instructions.
Any Release from Deep Power-down (RDP) in-
struction, while an Erase, Program or Write cycle
is in progress, is rejected without having any ef-
fects on the cycle that is in progress.
t
RDP
Stand-by Mode
RDP
, the device is put in the
M45PE80
AI06807
23/36