MOD-IO Olimex Ltd., MOD-IO Datasheet - Page 4

• Manufacturer Part Number: MOD-IO
• Description: Other Development Tools EXPANDABLE BRD INPUT/OUTPUT W/UEXT
• Manufacturer: Olimex Ltd.
• Type: Inputs/Outputsr

Specifications of MOD-IO

• Rohs: yes
• Product: Development Boards
• Tool Is For Evaluation Of: ATMega16L-8AU
• Operating Supply Voltage: 8 V to 30 V
• Description/function: MOD-IO is a small but powerful development board which lets you control 4 opto-isolated inputs and 4 relay outputs
• Dimensions: 100 mm x 80 mm
• Interface Type: I2C, SPI, UART, UEXT

ELECTROSTATIC WARNING
BOARD USE REQUIREMENTS
PROCESSOR FEATURES
The MOD-IO board is shipped in protective anti-static packaging. The board must
not be subject to high electrostatic potentials. General practice for working with
static sensitive devices should be applied when working with this board.
Cables:
Hardware:
Software:
MOD-IO use 8-bit AVR Microcontroller with 16K Bytes In-System Programmable
Flash, with these features:
–
–
–
High-performance, Low-power AVR
Advanced RISC Architecture
–
–
–
–
–
–
–
–
–
–
–
High Endurance Non-volatile Memory segments
131 Powerful Instructions – Most Single-clock Cycle Execution
32 x 8 General Purpose Working Registers
Fully Static Operation
Up to 16 MIPS Throughput at 16 MHz
On-chip 2-cycle Multiplier
16K Bytes of In-System Self-programmable Flash program memory
512 Bytes EEPROM
1K Byte Internal SRAM
Write/Erase Cycles: 10,000 Flash/100,000 EEPROM
Data retention: 20 years at 85°C/100 years at 25°C
Optional Boot Code Section with Independent Lock Bits
In-System Programming by On-chip Boot Program
True Read-While-Write Operation
The cable you will need depends on the programmer/debugger you
use. If you use AVR-PG1, or AVR-JTAG, you will need RS232 cable, if
you use AVR-PG2, you will need LPT cable, if you use AVR-USB-
JTAG, AVR-ISP500, AVR-ISP500-TINY, AVR-ISP500-ISO, AVR-ISP-
MK2 you will need 1.8 meter A-B USB cable.
One of Olimex programmers/debuggers – AVR-PG1, AVR-PG2,
AVR-ISP500, AVR-ISP500-TINY, AVR-ISP500-ISO, AVR-JTAG,
USB-JTAG, AVR-ISP-MK2
tool.
Make sure to check if the above programmer/debugger is supported
by the IDE you are going to use.
AVR C Compiler
Page 4
®
or other compatible programming/debugging
8-bit Microcontroller
AVR-