ST62T18CB6 STMicroelectronics, ST62T18CB6 Datasheet - Page 21

• Manufacturer Part Number: ST62T18CB6
• Description: 8-bit Microcontrollers - MCU OTP EPROM 8K SPI/UAR
• Manufacturer: STMicroelectronics

Specifications of ST62T18CB6

• Core: ST6
• Data Bus Width: 8 bit
• Maximum Clock Frequency: 8 MHz
• Program Memory Size: 7948 B
• Data Ram Size: 192 B
• On-chip Adc: Yes
• Operating Supply Voltage: 3 V to 6 V
• Package / Case: PDIP-20
• Mounting Style: Through Hole
• A/d Bit Size: 8 bit
• A/d Channels Available: 7
• Data Rom Size: 64 B
• Interface Type: UART
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 40 C
• Number Of Programmable I/os: 12
• Number Of Timers: 1
• Program Memory Type: EPROM
• Factory Pack Quantity: 20
• Supply Voltage - Max: 6 V
• Supply Voltage - Min: 3.6 V

RESETS (Cont’d)
3.2.3 Watchdog Reset
The MCU provides a Watchdog timer function in
order to ensure graceful recovery from software
upsets. If the Watchdog register is not refreshed
before an end-of-count condition is reached, the
internal reset will be activated. This, amongst oth-
er things, resets the watchdog counter.
The MCU restarts just as though the Reset had
been generated by the RESET pin, including the
built-in stabilisation delay period.
3.2.4 LVD Reset
The on-chip Low Voltage Detector, selectable as
user option, features static Reset when supply
voltage is below a reference value. Thanks to this
feature, external reset circuit can be removed
while keeping the application safety. This SAFE
RESET is effective as well in Power-on phase as
in power supply drop with different reference val-
Figure 14. LVD Reset on Power-on and Power-down (Brown-out)
3.2.5 Application Notes
No external resistor is required between V
the Reset pin, thanks to the built-in pull-up device.
V
V
V
DD
dn
Up
RESET
DD
and
ues, allowing hysteresis effect. Reference value in
case of voltage drop has been set lower than the
reference value for power-on in order to avoid any
parasitic Reset when MCU start's running and
sinking current on the supply.
As long as the supply voltage is below the refer-
ence value, there is a internal and static RESET
command. The MCU can start only when the sup-
ply voltage rises over the reference value. There-
fore, only two operating mode exist for the MCU:
RESET active below the voltage reference, and
running mode over the voltage reference as
shown on the
up, power-down sequence.
Note: When the RESET state is controlled by one
of the internal RESET sources (Low Voltage De-
tector, Watchdog, Power on Reset), the RESET
pin is tied to low logic level.
Direct external connection of the pin RESET to
V
haviour of the internal reset sources (AND.Wired
structure).
DD
must be avoided in order to ensure safe be-
Figure
14, that represents a power-
RESET
time
ST62T18C/E18C
VR02106A
21/82
21