M27W401-80K6 STMicroelectronics, M27W401-80K6 Datasheet - Page 11

• Manufacturer Part Number: M27W401-80K6
• Description: IC OTP 4MBIT 80NS 32PLCC
• Manufacturer: STMicroelectronics

Specifications of M27W401-80K6

• Format - Memory: EPROMs
• Memory Type: OTP EPROM
• Memory Size: 4M (512K x 8)
• Speed: 80ns
• Interface: Parallel
• Voltage - Supply: 2.7 V ~ 3.6 V
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 32-PLCC
• Density: 4Mb
• Organization: 512Kx8
• Interface Type: Parallel
• Bus Type: Parallel
• In System Programmable: External
• Access Time (max): 80ns
• Package Type: PLCC
• Reprogramming Technique: OTP
• Operating Supply Voltage (typ): 3.3V
• Operating Supply Voltage (min): 2.7V
• Operating Supply Voltage (max): 3.6V
• Supply Current: 50mA
• Pin Count: 32
• Mounting: Surface Mount
• Operating Temp Range: -40C to 85C
• Operating Temperature Classification: Industrial
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-1693-5

M27W401
2.10
M27W401, these two identifier bytes are given in
to Q0. Note that the M27W401 and M27C4001 have the same identifier bytes.
Table 3.
Erasure operation (applies to UV EPROM)
The erasure characteristics of the M27W401 are such that erasure begins when the cells
are exposed to light with wavelengths shorter than approximately 4000 Å. It should be noted
that sunlight and some type of fluorescent lamps have wavelengths in the 3000-4000 Å
range. Data shows that constant exposure to room level fluorescent lighting could erase a
typical M27W401 in about 3 years, while it would take approximately 1 week to cause
erasure when exposed to direct sunlight. If the M27W401 is to be exposed to these types of
lighting conditions for extended periods of time, it is suggested that opaque labels be put
over the M27W401 window to prevent unintentional erasure. The recommended erasure
procedure for the M27W401 is exposure to short wave ultraviolet light which has wavelength
of 2537 Å. The integrated dose (i.e. UV intensity x exposure time) for erasure should be a
minimum of 15 W-sec/cm
minutes using an ultraviolet lamp with 12000 W/cm
be placed within 2.5 cm (1 inch) of the lamp tubes during the erasure. Some lamps have a
filter on their tubes which should be removed before erasure.
Manufacturer’s Code
Device Code
Identifier
Electronic Signature
V
V
A0
IH
IL
2
. The erasure time with this dosage is approximately 15 to 20
Q7
0
0
Q6
0
1
Q5
1
0
Table 3
Q4
0
0
2
power rating. The M27W401 should
Q3
0
0
and can be read-out on outputs Q7
Q2
0
0
Q1
0
0
Device description
Q0
0
1
Hex Data
20h
41h
11/23