MAX16913AEVKIT+ Maxim Integrated, MAX16913AEVKIT+ Datasheet - Page 3

• Manufacturer Part Number: MAX16913AEVKIT+
• Description: Current & Power Monitors & Regulators Automotive Antenna Protector EVKIT
• Manufacturer: Maxim Integrated

Specifications of MAX16913AEVKIT+

• Product: Current Monitors
• Supply Voltage - Max: 18 V
• Supply Voltage - Min: 5 V
• Operating Temperature Range: - 40 C to + 105 C
• Input Voltage Range: 5 V to 18 V
• Supply Current: 1.2 mA

Table 2. Jumper JU2 Functions
* Default position.
Table 3. Jumper JU4 Function
* Default position.
Table 4. Jumper JU3 Function
(2-Pin Header Not Installed)
Not installed
Not installed
POSITION
POSITION
POSITION
Installed*
Installed
SHUNT
SHUNT
SHUNT
2-3*
1-2
Indicator LEDs (LED1 and LED2) used to
monitor fault signals
Indicator LEDs (LED1 and LED2) not used.
signals.
Connected to GND
_______________________________________________________________________________________
resistor-divider
and
Connected to
OPEN-LOAD THRESHOLD (mA)
OLT PIN
pads used to monitor fault
DESCRIPTION
10
15
EV kit configured to
evaluate the
MAX16913
EV kit configured to
evaluate the
MAX16913A
DESCRIPTION
MAX16913A Evaluation Kit
The open-load threshold setting is configured by the
resistor-divider between the REF and OLT device pins.
The MAX16913A EV kit provides for two threshold set-
tings that are selected by configuring jumper JU2. See
Table 2.
The MAX16913A EV kit includes LED1 and LED2 to
provide visual monitoring of the open-load and short-
circuit fault signals. LED1 monitors the open-load (OL)
signal and LED2 monitors the short-circuit (SC) signal.
Both LED networks are driven by the on-board LDO
voltage (5V). To monitor the indicator outputs by exter-
nal means, remove the shunt from jumper JU4 and con-
nect the monitoring system to the OL and SC pads.
Ensure that the monitoring system provides pullup
resistors on the open-drain indicator output pins, OL
and SC. See Table 3.
The MAX16913A EV kit can also be used to evaluate
the MAX16913 device. The open-load threshold for the
MAX16913 device is internally set. As such, when eval-
uating the MAX16913 device the OLT resistor-divider
network is not needed and jumper JU3 should be
installed and configured with a shunt. See Table 4.
Open-Drain Fault Signals ( OL , SC )
Open-Load Threshold (JU2)
Evaluating the MAX16913
3