MAX16913AEVKIT+ Maxim Integrated, MAX16913AEVKIT+ Datasheet - Page 2

• Manufacturer Part Number: MAX16913AEVKIT+
• Description: Current & Power Monitors & Regulators Automotive Antenna Protector EVKIT
• Manufacturer: Maxim Integrated

Specifications of MAX16913AEVKIT+

• Product: Current Monitors
• Supply Voltage - Max: 18 V
• Supply Voltage - Min: 5 V
• Operating Temperature Range: - 40 C to + 105 C
• Input Voltage Range: 5 V to 18 V
• Supply Current: 1.2 mA

Before beginning, the following equipment is needed:
• 18V power supply
• Load
• Voltmeter
The MAX16913A EV kit is fully assembled and tested.
Follow the steps below to verify board operation.
Caution: Do not turn on power until all connections
are completed.
1) Verify that shunts are installed on jumpers JU1 and
2) Verify that the shunt on jumper JU2 is shorting pins
3) Connect the power supply across the VIN and GND
4) Connect the load across the OUT and GND pads.
5) Configure the power supply for 10V.
6) Configure the load for 20mA.
7) Enable the power supply then enable the load.
8) Verify that AOUT is approximately 0.66V.
MAX16913A Evaluation Kit
Note: Indicate that you are using the MAX16913/MAX16913A when contacting these component suppliers.
2
Fairchild Semiconductor
KEMET Corp.
Murata Electronics North America, Inc.
Panasonic Corp.
SANYO Semiconductor (U.S.A.) Corp.
TDK Corp.
Vishay
JU4.
2-3.
pads.
_______________________________________________________________________________________
SUPPLIER
Recommended Equipment
Quick Start
Procedure
847-803-6100
888-522-5372
864-963-6300
770-436-1300
800-344-2112
201-825-8080
402-563-6866
PHONE
The MAX16913A evaluation kit (EV kit) evaluates the
MAX16913A high-voltage, high-side current-sense
switches. The EV kit operates from a DC supply voltage
from 5V to 18V. The EV kit demonstrates the device’s
open-drain fault signals (OL and SC), open-load thresh-
old setting input (OLT), and shutdown function (SHDN).
The MAX16913A EV kit provides LED1 and LED2 to
facilitate the monitoring of the open-load and short-cir-
cuit open-drain fault signals, respectively. The open-
load threshold setting input is configurable for two
possible settings using jumper JU2.
An on-board LDO (U2) is provided to support single-
supply evaluation. The LDO is powered by the input
supply voltage (VIN) and provides a 5V output (LDO),
used to source the on-board indicator LEDs.
The EV kit can also be used to evaluate the MAX16913,
which features an internally set open-load threshold.
See the Evaluating the MAX16913 section.
The MAX16913A EV kit provides jumper JU1 to config-
ure the devices shutdown pin (SHDN). See Table 1.
Table 1. Jumper JU1 Functions
* Default position.
Detailed Description of Hardware
Not installed
POSITION
Installed*
SHUNT
Connected to GND
www.fairchildsemi.com
www.kemet.com
www.murata-northamerica.com
www.panasonic.com
http://semicon.us.sanyo.com
www.component.tdk.com
www.vishay.com
Connected to LDO
(5V) through R2
Component Suppliers
SHDN PIN
WEBSITE
Shutdown (JU1)
Device enabled
Device disabled
DESCRIPTION