AP-SDM001G1PANS-HT Apacer, AP-SDM001G1PANS-HT Datasheet - Page 27

• Manufacturer Part Number: AP-SDM001G1PANS-HT
• Description: Solid State Drives - SSD SDM2 22P/90D SATA DISK MOD SLC 1GB ST
• Manufacturer: Apacer

Specifications of AP-SDM001G1PANS-HT

• Rohs: yes
• Product: SATA Disk Modules
• Memory Size: 1 GB
• Sustained Read: 100 MB/s
• Sustained Write: 88 MB/s
• Active Mode Current: 260 mA
• Operating Supply Voltage: 5 V
• Maximum Operating Temperature: + 70 C
• Connector Type: 7-pin signal, 15-pin power
• Dimensions: 44 mm x 30 mm
• Minimum Operating Temperature: 0 C

SATA-Disk Module
Ⅱ Ⅱ Ⅱ Ⅱ
AP-SDMxxxx1PAXS-HT
device lifespan. The process to erase will not be stopped until finished while encountering power failure, and
will be continued when power is back on.
3.6
S.M.A.R.T.
S.M.A.R.T. is an acronym for Self-Monitoring, Analysis and Reporting Technology, an open standard allowing
disk drives to automatically monitor their own health and report potential problems. It protects the user from
unscheduled downtime by monitoring and storing critical drive performance and calibration parameters. Ideally,
this should allow taking proactive actions to prevent impending drive failure.
Apacer SMART feature follows the SATA Rev. 2.5, ATA/ATAPI-7 specifications, using the standard SMART
command B0h to read data from the drive. And based on the SFF-8035i Rev. 2.0 specifications, Apacer
SMART defines 3 vendor-specified SMART Attribute IDs (E5h, E8h-EFh, and F3h) in the SDM. They
represent Flash ID, good block count, free-list block count, maximum erase count, average erase count, and
firmware version information. When the Apacer SMART Utility running on the host, it analyzes and reports the
disk status to the host before the SDM is in critical condition.
26
© 2011 Apacer Technology Inc.
Rev. 1.3