TDK5100F_08 INFINEON [Infineon Technologies AG], TDK5100F_08 Datasheet - Page 14
![no-image](/images/no-image-200.jpg)
TDK5100F_08
Manufacturer Part Number
TDK5100F_08
Description
434 MHz ASK/FSK Transmitter in 10-pin Package
Manufacturer
INFINEON [Infineon Technologies AG]
Datasheet
1.TDK5100F_08.pdf
(39 pages)
Table 5
ASKDTA (pin6)
Low
Open
1) Low:
2) Open:
3) High:
The Power Amplifier has an Open Collector output at PAOUT (pin 9) and requires an
external pull-up coil to provide bias. The coil is part of the tuning and matching LC
circuitry to get best performance with the external loop antenna. To achieve the best
power amplifier efficiency, the high frequency voltage swing at PAOUT (pin 9) should be
twice the supply voltage.
The power amplifier has its own ground pin PAGND (pin 8) in order to reduce the amount
of coupling to the other circuits.
2.4.4
The IC provides three power modes, the POWER DOWN MODE, the PLL ENABLE
MODE and the TRANSMIT MODE.
2.4.4.1
In the POWER DOWN MODE the complete chip is switched off.
The current consumption is typically 0.3 nA at 3 V 25°C.
This current doubles every 8°C. The values for higher temperatures are
typically 14 nA at 85°C and typically 600 nA at 125°C.
2.4.4.2
In the PLL ENABLE MODE the PLL is switched on but the power amplifier is turned off
to avoid undesired power radiation during the time the PLL needs to settle. The turn on
time of the PLL is determined mainly by the turn on time of the crystal oscillator and is
less than 1 ms when the specified crystal is used.
The current consumption is typically 3.5 mA (in PLL Enable Mode).
Data Sheet
1)
2)
, High
Power Modes
Power Down Mode
PLL Enable Mode
3)
ASKDTA - Power Amplifier
Voltage at pin < 0.5V
Pin open
Voltage at pin > 1.5V
Power Amplifier
OFF
ON
14
Functional Description
V 1.2, 2008-04-04
TDK5100F