LUCL9216AGF-D AGERE [Agere Systems], LUCL9216AGF-D Datasheet - Page 26

• Manufacturer Part Number: LUCL9216AGF-D
• Description: Short-Loop Ringing SLIC with Ground Start
• Manufacturer: AGERE [Agere Systems]

Short-Loop Ringing SLIC with Ground Start
Supervision
Power Ring
Sine Wave Input Signal and Sine Wave Power Ring
Signal Output
The low-voltage sine wave input is applied to the L9216
at pin RING
through 0.47 F. During the ring mode, the signal at
RING
loop. The differential gain from RING
a nominal 55.
When the device enters the ring mode, the tip/ring
overhead set at OVH and the scan clamp circuit is dis-
abled, allowing the voltage magnitude of the power ring
signal to be maximized. Additionally, in the ring mode,
the loop current limit is increased 2.5X the value set by
the V
The magnitude of the power ring voltage will be a func-
tion of the gain of the ring amplifier, the high voltage
battery, and the input signal at RING
of the signal at RING
age at RING
ring voltage at tip and ring will increase linearly, per the
differential gain of 55, until the tip and ring drive amplifi-
ers begin to saturate. Once the tip and ring amplifiers
reach saturation, further increases of the input signal
will cause clipping distortion of the power ring signal
at tip and ring. The ring signal will appear balanced on
tip and ring. That is, the power ring signal is applied
to both tip and ring, with the signal on tip 180
(180 degrees) out of phase from the signal on ring.
Figure 11 shows typical operation of the ring mode,
prior to saturation of the tip and ring drive amplifiers. A
–70 V battery is used with a 100
load. The input signal is 1 V through a 0.47 F capaci-
tor at RING
This produces a voltage swing from –34 V to –60 V
26
PROG
IN
is amplified and presented to the subscriber
voltage.
IN
IN
IN
, (the input circuit is shown in Figure 12).
. This signal should be ac-coupled
is increased, the magnitude of the power
(continued)
(continued)
IN
is 0 V to Vcc. As the input volt-
loop and a 1 REN
IN
IN
. The input range
to tip and ring is
on ring and from –8 V to –34 V on tip, as shown in
Figure 11. Thus, the total voltage swing is 52 V (60 V to
8 V) for a 1 V input, which is approximately the differen-
tial gain of the device. Note that the tip and ring power
ring signals will swing around V
In this case, there is a –70 V battery so tip and ring
swing around –34 V.
–0.5
–1.0
–20
–40
–60
1.0
0.5
0.0
0
0.60 0.62
0.60 0.62
Figure 11. Ring Mode Typical Operation
0.64
0.64
0.66
0.66
0.68
0.68
VRING
VRINGIN
TIME
TIME
0.70
0.70
BATTERY
0.72
0.72
September 2001
Agere Systems Inc.
0.74
0.74
divided by two.
VTIP
0.76
0.76
0.78
0.78
12-3573F
12-3574F
0.80
0.80