AFBR-732BE HP [Agilent(Hewlett-Packard)], AFBR-732BE Datasheet - Page 4

• Manufacturer Part Number: AFBR-732BE
• Description: Ultra Short Link Pluggable Parallel Fiber Optic Modules, Transmitter and Receiver
• Manufacturer: HP [Agilent(Hewlett-Packard)]

Electromagnetic Interference (EMI)
Many equipment designs using
these high-data-rate modules
will be required to meet the
requirements of the FCC in the
United States, CENELEC in
Europe and VCCI in Japan.
These modules, with their
shielded design, perform to the
levels detailed in the
Regulatory Compliance Table.
The performance detailed in the
Regulatory Compliance Table is
intended to assist the
equipment designer in the
management of the overall
equipment EMI performance.
However, system margins are
dependent on the customer
board and chassis design.
Immunity
Equipment using these modules
will be subject to radio
frequency electromagnetic fields
in some environments. These
modules have good immunity
due to their shielded designs.
See the Regulatory Compliance
Table for further detail.
4
Eye Safety
These 850 nm VCSEL-based
modules provide eye safety by
design. The AFBR-732B has
been registered with CDRH and
certified by TUV as a Class 1M
device under Amendment 2 of
IEC 60825-1. See the
Regulatory Compliance Table
for further detail. If Class 1M
exposure is possible, a safety-
warning label should be placed
on the product stating the
following:
LASER RADIATION
DO NOT VIEW DIRECTLY
WITH OPTICAL INSTRUMENTS
CLASS 1M LASER PRODUCT
Connector Cleaning
The optical connector used is
the MTP® (MPO). The optical
ports have recessed optics that
are visible through the nose of
the ports. The provided port
plug should be installed any
time a fiber cable is not
connected. The port plug
ensures the optics remain clean
and no cleaning should be
necessary. In the event the
optics become contaminated,
forced nitrogen or clean dry air
at less than 20 psi is the
recommended cleaning agent.
The optical port features,
including guide pins, preclude
use of any solid instrument.
Liquids are not advised due to
potential damage.
Process Plug
Each parallel optics module is
supplied with an inserted
process plug for protection of
the optical ports within the
MTP® (MPO) connector
receptacle.
Handling Precautions
The AFBR-732B and AFBR-
742B can be damaged by
current surges and overvoltage
conditions. Power supply
transient precautions should be
taken.
Application of wave soldering,
reflow soldering and/or aqueous
wash processes with the
parallel optic device on board
is not recommended as damage
may occur.
Normal handling precautions
for electrostatic sensitive
devices should be taken (see
ESD section).
The AFBR-732B is a Class 1M
laser product. DO NOT VIEW
RADIATION DIRECTLY WITH
OPTICAL INSTRUMENTS.