MAAP-000076-MCH000 MACOM [Tyco Electronics], MAAP-000076-MCH000 Datasheet - Page 7

• Manufacturer Part Number: MAAP-000076-MCH000
• Description: Amplifier, Power, 16W 1.3-2.5 GHz
• Manufacturer: MACOM [Tyco Electronics]

7
M/A-COM Inc. and its affiliates reserve the right to make changes to the
product(s) or information contained herein without notice. M/A-COM makes
no warranty, representation or guarantee regarding the suitability of its
products for any particular purpose, nor does M/A-COM assume any liability
whatsoever arising out of the use or application of any product(s) or
information.
Amplifier, Power, 16W
1.3-2.5 GHz
Recommended Layout and Wire Bonding Configuration
In implementing the DC/ RF crossover shown, the following rules must applied.
1.
2.
3.
4.
Power Supply Sequencing:
Must apply negative bias to V
Die Handling:
Refer to Application Note AN3016.
Application%20Notes/index.htm.
the DC crossovers should approach and cross the RF trace at a 90 degree angle;
the printed DC traces that approach the RF line should be stopped 2 substrate heights from the RF line edge;
the rated current capability of the DC crossovers should be greater than the maximum current of the device; and
the wires or ribbons used to make the DC crossovers should clear the RF trace by ~ 1 substrate height.
V
GG
VDD
VGG
Gnd
RF
GG
Crossover
GND
before applying positive bias to V
0.1 F
0.01-
Gate
GND
RF
All Application Notes may be accessed by going to http://www.macom.com/
100
IN
100-
200
100-
pF
200
pF
• North America Tel: [phone] / Fax: [phone]
• Europe Tel: [phone] / Fax: [phone]
• Asia/Pacific Tel: [phone] / Fax: [phone]
Visit www.macom.com for additional data sheets and product information.
100-
200
100-
200
pF
pF
100-
200
100-
pF
200
pF
DD
to prevent damage to amplifier.
100-
200
100-
pF
200
pF
0.1 F
0.01-
V
DD
MAAP-000076-PED000
RF
Crossover
OUT
Drain
Preliminary Datasheet
Rev —