RT9241A RICHTEK [Richtek Technology Corporation], RT9241A Datasheet - Page 5

• Manufacturer Part Number: RT9241A
• Description: Two-Phase DC/DC Controller for CPU Core Power Supply
• Manufacturer: RICHTEK [Richtek Technology Corporation]

Functional Pin Description
VID4, VID3, VID2, VID1 and VID0 ( Pin1,2,3,4,5)
DAC voltage identification inputs for VRM9.0. These pins
are TTL-compatible and internally pulled to VDD if left
open.
COMP (Pin 6)
Output of the error amplifier and input of the PWM
comparator.
FB (Pin 7)
Inverting input of the internal error amplifier.
ADJ (Pin 8)
Current sense output for active droop adjust. Connect a
resistor from this pin to GND to set the amount of load
droop. This pin should not be opened.
DVD (Pin 9)
Programmable power UVLO detection input. Trip threshold
= 1.25V at V
SS (Pin 10)
Connect this SS pin to GND with a capacitor to set the
start time interval. Pull this pin below 1V (ramp valley of
saw-tooth wave in pulse width modulator) to shutdown
the converter output.
ISN1 (Pin 12), ISN2 (Pin 11)
Current sense inputs from the individual converter channel's
sense component GND nodes.
GND (Pin 13)
Ground for the IC.
VSEN (Pin 14)
Power good and over voltage monitor input. Connect to
the microprocessor-CORE voltage.
ISP1 (Pin 18), ISP2 (Pin 15)
Current sense inputs for individual converter channels. Tie
this pin to the component sense node.
DS9241AB-05 March 2007
DVD
rising
PWM1 (Pin 17), PWM2 (Pin 16)
PWM outputs for each driven channel. Connect these pins
to the PWM input of the MOSFET driver.
PGOOD (Pin 19)
Power good open-drain output.
VDD (Pin 20)
IC power supply. Connect this pin to a 5V supply.
RT9241A/B
www.richtek.com
5