ATA5423_06 ATMEL [ATMEL Corporation], ATA5423_06 Datasheet - Page 47

• Manufacturer Part Number: ATA5423_06
• Description: UHF ASK/FSK Transceiver
• Manufacturer: ATMEL [ATMEL Corporation]

7.7
7.8
4841C–WIRE–05/06
Low Battery Indicator
Pin VAUX
The status bit Low_Batt is set to “1” if the voltage V
(typically).
Low_Batt is set to “0” if V
serial interface (see
Figure 7-5.
To switch the transceiver from OFF to AUX mode, the voltage V
3.5V (typically) (see
to low, and DVCC and the power supply for external devices VSOUT are switched on.
If V
After the voltage on pin VSOUT exceeds 2.3V (typically) and the start-up time of the XTO is
elapsed, the output clock on pin CLK is available. Because the enabling of pin CLK is asynchro-
nous, the first clock cycle may be incomplete. N_RESET is set to high if V
(typically) and the XTO is settled.
If the transceiver is in any active mode (IDLE, TX, RX, RX_Polling), a positive edge on pin VAUX
and V
an interrupt. If P_On_Aux is still “1” during the positive edge on pin VAUX no interrupt is issued.
P_On_Aux and the interrupt are deleted after reading the status register.
VAUX
VAUX
exceeds 3.5V (typically) the status bit P_On_Aux is set to “1” and an interrupt is issued.
> VS1 + 0.5V sets P_On_Aux to “1”. The state transition P_On_Aux 0 → 1 generates
Timing Status Bit Low_Batt
Figure 5-3 on page
Figure 7-6 on page
VSOUT
exceeds V
IDLE, AUX, TX, RX or
Read Status Register
V
VSOUT
RX Polling Mode
Low_Batt = 1
34).
< 2.38 V (typ)
48). If V
?
Thres_2
Y
VAUX
and the status register is read via the 4-wire
exceeds 2V (typically) pin N_RESET is set
VSOUT
N
on pin VSOUT drops below 2.38V
ATA5423/25/28/29
VAUX
on pin VAUX must exceed
VSOUT
exceeds 2.38V
47