LPC2220 PHILIPS [NXP Semiconductors], LPC2220 Datasheet - Page 26

• Manufacturer Part Number: LPC2220
• Description: 16/32-bit ARM microcontrollers; flashless with 64 kB, with 10-bit ADC and external memory interface
• Manufacturer: PHILIPS [NXP Semiconductors]

Philips Semiconductors
9397 750 14061
Product data sheet
6.18.1 Features
6.19.1 Features
6.18 Real-time clock
6.19 Pulse width modulator
The RTC is designed to provide a set of counters to measure time when normal or idle
operating mode is selected. The RTC has been designed to use little power, making it
suitable for battery powered systems where the CPU is not running continuously (Idle
mode).
The PWM is based on the standard Timer block and inherits all of its features, although
only the PWM function is pinned out on the LPC2210/2220. The Timer is designed to
count cycles of the peripheral clock (PCLK) and optionally generate interrupts or perform
other actions when specified timer values occur, based on seven match registers. The
PWM function is also based on match register events.
The ability to separately control rising and falling edge locations allows the PWM to be
used for more applications. For instance, multi-phase motor control typically requires three
non-overlapping PWM outputs with individual control of all three pulse widths and
positions.
Two match registers can be used to provide a single edge controlled PWM output. One
match register (MR0) controls the PWM cycle rate, by resetting the count upon match.
The other match register controls the PWM edge position. Additional single edge
controlled PWM outputs require only one match register each, since the repetition rate is
the same for all PWM outputs. Multiple single edge controlled PWM outputs will all have a
rising edge at the beginning of each PWM cycle, when an MR0 match occurs.
Three match registers can be used to provide a PWM output with both edges controlled.
Again, the MR0 match register controls the PWM cycle rate. The other match registers
control the two PWM edge positions. Additional double edge controlled PWM outputs
require only two match registers each, since the repetition rate is the same for all PWM
outputs.
With double edge controlled PWM outputs, specific match registers control the rising and
falling edge of the output. This allows both positive going PWM pulses (when the rising
edge occurs prior to the falling edge), and negative going PWM pulses (when the falling
edge occurs prior to the rising edge).
•
•
•
•
•
Measures the passage of time to maintain a calendar and clock.
Ultra-low power design to support battery powered systems.
Provides Seconds, Minutes, Hours, Day of Month, Month, Year, Day of Week, and Day
of Year.
Programmable Reference Clock Divider allows adjustment of the RTC to match
various crystal frequencies.
Seven match registers allow up to six single edge controlled or three double edge
controlled PWM outputs, or a mix of both types.
16/32-bit ARM microcontrollers with external memory interface
Rev. 02— 30 May 2005
© Koninklijke Philips Electronics N.V. 2005. All rights reserved.
LPC2210/2220
26 of 49