BCRT-ACA ETC1 [List of Unclassifed Manufacturers], BCRT-ACA Datasheet - Page 4

• Manufacturer Part Number: BCRT-ACA
• Description: BCRT Bus Controller/Remote Terminal/Monitor
• Manufacturer: ETC1 [List of Unclassifed Manufacturers]

Control Register (Write Only)
The host microprocessor gains access to the RTI internal
registers by controlling input pins CS, CTRL, ADDR IN
(10:0), and RD/WR. During message processing the host
microprocessor should limit access to RTI internal registers.
1.1.2 Transparent Memory Access
Configured in the transparent memory mode the host
microprocessor accesses shared memory through the RTI.
Arbitration for access to the bus is performed as discussed
in section 1.1.1 of this document.
When granted access to memory, the RTI asserts memory
control signals ADDR OUT(10:0), RCS, and RRD/RWR.
For host-controlled memory accesses the RAM memory
address from the host is propagated from the Address In bus
ADDR IN (10:0) to the Address Out bus ADDR OUT (10:0).
Memory control signals RD/WR and CS are also propagated
through the RTI as RRD/RWR and RCS. Input CTRL is
negated during all transparent memory accesses to prevent
the RTI from inadvertently performing an internal register
access or software reset. While CS is asserted, the RTI’s
bidirectional Data bus DATA I/O (15:0) is an input (i.e., not
actively driving bus).
Computer
Host
Computer
Host
ADDR IN (10:0)
DATA I/O (15:0)
CONTROL
CONTROL
DATA(15:0)
ADDR(10:0)
Figure 3. Transparent Memory Access Configuration
Figure 2. Direct Memory Access Configuration
UT1553B
Memory
CONTROLLER
Shared
RTI
DATA(15:0)
CONTROLLER
DMA
The host microprocessor gains access to the RTI internal
registers by controlling input pins CS, CTRL, ADDR IN
(10:0), and RD/WR. During message processing the host
microprocessor should limit access to RTI internal registers.
The host should not assert CS while the RTI is performing
a memory access.
1.2 Internal Register Description
The RTI uses three internal registers to allow the host to
control the RTI operation and monitor its status. The host
uses the following inputs Control (CTRL), Chip Select
(CS), Read/Write (RD/WR), and ADDR IN (0) to read the
16-bit System Register or write to the 8-bit Control Register.
The Control Register toggles bits in the MIL-STD-1553B
status word, enables biphase inputs, selects terminal active
flag, and puts the part in self-test. The System Register
supplies operational status of the UT1553B RTI to the host.
The Last Command Register saves the command word for
a Transmit Last Command mode code, along with
operational status from the System Register.
DMA
CONTROL
ADDR OUT (10:0)
CONTROL
UT1553B
RTI
Memory
Shared
RTI-4