NCP1246 ONSEMI [ON Semiconductor], NCP1246 Datasheet - Page 36

• Manufacturer Part Number: NCP1246
• Description: Fixed Frequency Current Mode Controller for Flyback Converters
• Manufacturer: ONSEMI [ON Semiconductor]

LatchïOff Input
includes two levels of detection that define a working
window, between a high latch and a low latch: within these
two thresholds, the controller is allowed to run, but as soon
as either the low or the high threshold is crossed, the
controller is latched off. The lower threshold is intended to
be used with an NTC thermistor, thanks to an internal current
source I
high threshold if it is only pulled up by the I
reach the high threshold, the pullïup current has to be higher
than the pullïdown capability of the clamp (typically
1.5 mA at V
(for the high latch and 65 kHz version) or 350 ms (for the low
latch) are blanked and only longer signals can actually latch
the controller.
C
The Latch pin is dedicated to the latchïoff function: it
An active clamp prevents the voltage from reaching the
To avoid any false triggering, spikes shorter than 50 ms
LATCH max
NTC
.
OVP
+
).
T
SSTART min
V
clamp0 min
@ I
NTC(SSTART) min
Figure 70. Latch Detection Schematic
NTC
+
current. To
8.0 @ 10
http://onsemi.com
NCP1246
ï3
1.0
36
@ 130 @ 10
the V
application can only happen if the power supply is
unplugged from the ac line.
before being at their nominal values; so one of the
comparators could toggle even if it should not. Therefore the
internal logic does not take the latch signal into account
before the controller is ready to start: once V
V
and the DRV switching starts only if it is allowed; whereas
the Low latch (typically sensing an over temperature) is
taken into account only after the softïstart is finished. In
addition, the NTC current is doubled to I
the softïstart period, to speed up the charging of the Latch
pin capacitor. The maximum value of Latch pin capacitor is
given by the following formula (The standard startïup
condition is considered and the NTC current is neglected):
CC(on)
Reset occurs when a brownïout condition is detected or
Upon startup, the internal references take some time
CC
ï6
, the latch pin High latch state is taken into account
is cycled down to a reset voltage, which in a real
F + 1.04 mF
(eq. 4)
NTC(SSTART)
CC
reaches
during