AT88SC0204C-SU ATMEL [ATMEL Corporation], AT88SC0204C-SU Datasheet - Page 11

• Manufacturer Part Number: AT88SC0204C-SU
• Description: CryptoMemory 2 Kbit
• Manufacturer: ATMEL [ATMEL Corporation]

Figure 12. Write Lock Example
Password Verification
Authentication Protocol
2022HS–SMEM–04/07
Address
$080
11011001
$0
xxxx xxxx
locked
$1
The write lock byte may also be locked by writing its least significant (rightmost) bit to
“0”. Moreover, when write lock mode is activated, the write lock byte can only be pro-
grammed – that is, bits written to “0” cannot return to “1”.
In the write lock configuration, only one byte can be written at a time. Even if several
bytes are received, only the first byte will be taken into account by the device.
Passwords may be used to protect read and/or write access of any user zone. When a
valid password is presented, it is memorized and active until power is turned off, unless
a new password is presented or RST becomes active. There are eight password sets
that may be used to protect any user zone. Only one password is active at a time, but
write passwords give read access also.
The access to a user zone may be protected by an authentication protocol. Any one of
four keys may be selected to use with a user zone.
The authentication success is memorized and active as long as the chip is powered,
unless a new authentication is initialized or RST becomes active. If the new authentica-
tion request is not validated, the card loses its previous authentication and it should be
presented again. Only the last request is memorized.
Note:
Figure 13. Password and Authentication Operations
Password and authentication may be presented at any time and in any order. If the trials
limit has been reached (after four consecutive incorrect attempts), the password verifica-
tion or authentication process will not be taken into account.
xxxx xxxx
locked
$2
Checksum (CS)
VERIFY RPW
VERIFY CS
Write DATA
DATA
xxxx xxxx
$3
xxxx xxxx
$4
xxxx xxxx
locked
$5
VERIFY CS
CS
AT88SC0204C
xxxx xxxx
$6
xxxx xxxx
$7
11