SAK-XC164CS-32F20F INFINEON [Infineon Technologies AG], SAK-XC164CS-32F20F Datasheet - Page 57

• Manufacturer Part Number: SAK-XC164CS-32F20F
• Description: 16-Bit Single-Chip Microcontroller with C166SV2 Core
• Manufacturer: INFINEON [Infineon Technologies AG]

Table 11
Parameter
Level inactive hold
current
Level active hold
current
XTAL1 input current
Pin capacitance
(digital inputs/outputs)
1) Keeping signal levels within the limits specified in this table, ensures operation without overload conditions.
2) This parameter is tested for P3, P4, P9.
3) The maximum deliverable output current of a port driver depends on the selected output driver mode, see
4) As a rule, with decreasing output current the output levels approach the respective supply level (
5) This specification is not valid for outputs which are switched to open drain mode. In this case the respective
6) An additional error current (
7) This specification is valid during Reset for configuration on RD, WR, EA, PORT0
8) The maximum current may be drawn while the respective signal line remains inactive.
9) The minimum current must be drawn to drive the respective signal line active.
10) This specification is valid during Reset for configuration on ALE.
11) This specification is valid during Reset for pins P4.3-0, which can act as CS outputs, and for P3.12.
12) Not subject to production test - verified by design/characterization.
Data Sheet
For signal levels outside these specifications, also refer to the specification of the overload current
Table
V
output will float and the voltage results from the external circuitry.
the definition of the overload coupling factor
OH
→
11)
11)
12,
V
DDP
Current Limits for Port Output
). However, only the levels for nominal output currents are guaranteed.
DC Characteristics (Operating Conditions apply)
12)
I
Symbol
I
I
I
C
INJ
LHI
LHA
IL
IO
) will flow if an overload current flows through an adjacent pin. Please refer to
8)
9)
CC –
CC –
Drivers. The limit for pin groups must be respected.
K
OV
Min.
–
-100
.
55
Limit Values
Max.
-10
–
±20
10
Unit Test Condition
µA
µA
µA
pF
1)
Electrical Parameters
(cont’d)
V
V
V
0 V <
–
OUT
DDP
OUT
Derivatives
V1.0, 2005-06
= 0.5 ×
= 0.45 V
V
XC164-32
IN
V
<
OL
I
OV
V
→
.
DDI
V
SS
,