STDVE001ABTR STMICROELECTRONICS [STMicroelectronics], STDVE001ABTR Datasheet - Page 18

• Manufacturer Part Number: STDVE001ABTR
• Description: Adaptive single 3.4 Gbps TMDS/HDMI signal equalizer
• Manufacturer: STMICROELECTRONICS [STMicroelectronics]

Functional description
3.7
3.8
18/49
Bias
The bandgap reference voltage over the external R
bias reference current. This current and its factors (achieved by employing highly accurate
and well matched current mirror circuit topologies) are generated on-chip and used by
several internal modules. The 10 mA current used by the transmitter block is also generated
using this reference current. It is important to ensure that the R
tolerance range of its typical value.
Table 5.
The output voltage swing depends on 3 components: supply voltage (V
resistor (R
termination resistor can vary from 50
The voltage on the output is given by:
V
The variation on I
the HDMI specification under all conditions.
This is achieved when:
400 mV
Timing between HPD and DDC
It is important to ensure that the I
complete.
As soon as the discovery is finished by the HPD detection, the configuration data is
exchanged between a source and sink through the I
DDC interface is ready for communication as soon as the power supply to the chip is
present and stable. When the desired port is enabled and the chip is out of shutdown mode,
the I
Thus, as soon as the HPD detection sequence is complete, the DDC interface can be
readily used. There is no delay between the HPD detection and I
ready.
Bandgap voltage
supply
Parameter
2
C DDC lines can be used for communication.
−
≤
I
drive
I
drive
T
) and current drive (I
Bias parameter
x R
x R
T
drive
.
T
≤
600 mV with typical value centered at 500 mV.
must be controlled to ensure that the voltage on HDMI output is within
Min
drive
2
C DDC interface is ready by the time the HPD detection is
). The supply voltage can vary from 3.3 V
Ω ±
10%.
Typ
1.2
EXT
2
C DDC interface. The STDVE003 Afs
reference resistor sets the internal
Max
EXT
2
C DDC interface to be
value is within the ±1%
supply)
, termination
±
5%,
STDVE001A
Unit
V