TDA5250D2_07 INFINEON [Infineon Technologies AG], TDA5250D2_07 Datasheet - Page 74

• Manufacturer Part Number: TDA5250D2_07
• Description: ASK/FSK 868MHz Wireless Transceiver
• Manufacturer: INFINEON [Infineon Technologies AG]

based software WinQSIM via a GPIB interface. The AMIQ generator has a pseudo random binary
sequence (PRBS) generator and a bit error test set built in. The resulting I/Q signals are applied to
the SMIQ to generate a ASK (OOK) spectrum at the desired RF frequency.
Data is demodulated by the TDA5250 and then sent back to the AMIQ to be compared with the
originally sent data. The bit error rate is calculated by the bit error rate equipment inside the AMIQ.
Baseband coding in the form of Manchester is applied to the I signal as can be seen in the
subsequent figure.
Figure 3-36
In the following figures the RF power level shown is the average power level.
These investigations have been made on an Infineon evaluation board using a data rate of 4 kBit/
s with manchester encoding and a data filter bandwidth of 7 kHz. This is the standard configuration
of our evaluation boards. All these measurements have been performed with several evaluation
boards, so that production scattering and component tolerances are already included in these
results.
Regarding the data filter bandwidth it has to be mentioned that a data rate of 4 kBit/s using
manchester encoding results in a data frequency of 2 kHz to 4 kHz depending on the occurring
data pattern. The test pattern given by the AMIQ is a pseudo random binary sequency (PRBS9)
with a 9 bit shift register. This pattern varies the resulting data frequency up to 4 kHz.
Data Sheet
BER Test Setup
RS 232
GPIB /
Personal Computer
WinIQSIM
Software
Marker Output
Rohde & Schwarz
I/Q Modulation Source
AMIQ
Rohde & Schwarz
Vector Signal Generator
SMIQ 03
ASK / FSK RF Signal
Manchester
Encoder
I
Q
(Bit Error Rate
AMIQ BERT
Test Set)
74
Clock
Data
RFin
Transceiver Testboard
TDA5250
Manchester
Decoder
DATAout
DUT
TDA5250 D2
Version 1.7
Application
2007-02-26
TestSetup.wmf