SAB80C537 INFINEON [Infineon Technologies AG], SAB80C537 Datasheet - Page 37

• Manufacturer Part Number: SAB80C537
• Description: 8-Bit CMOS Single-Chip Microcontroller
• Manufacturer: INFINEON [Infineon Technologies AG]

SAB 80C517/80C537
I/O Ports
The SAB 80C517 has seven 8-bit I/O ports and two input ports (8-bit and 4-bit wide).
Port 0 is an open-drain bidirectional I/O port, while ports 1 to 6 are quasi-bidirectional I/O ports
with internal pull-up resistors. That means, when configured as inputs, ports 1 to 6 will be pulled
high and will source current when externally pulled low. Port 0 will float when configured as
input.
Port 0 and port 2 can be used to expand the program and data memory externally. During an
access to external memory, port 0 emits the low-order address byte and reads/writes the data
byte, while port 2 emits the high-order address byte. In this function, port 0 is not an open-drain
port, but uses a strong internal pullup FET. Port 1, 3, 4, 5 and port 6 provide several alternate
functions. Please see the "Pin Description" for details.
Port pins show the information written to the port latches, when used as general purpose port.
When an alternate function is used, the port pin is controlled by the respective peripheral unit.
Therefore the port latch must contain a "one" for that function to operate. The same applies
when the port pins are used as inputs. Ports 1, 3, 4 and 5 are bit- addressable.
The SAB 80C517 has two dual-purpose input ports. The twelve port lines at port 7 and port 8
can be used as analog inputs for the A/D converter. If input voltages at P7 and P8 meet the
specified digital input levels (V
and V
the port can also be used as digital input port.
IH )
IL
Semiconductor Group
36