LPC47M140-NC SMSC [SMSC Corporation], LPC47M140-NC Datasheet - Page 89

• Manufacturer Part Number: LPC47M140-NC
• Description: 128 PIN ENGANCED SUPER I/O CONTROLLER WITH AN LPC INTERFACE AND USB HUB
• Manufacturer: SMSC [SMSC Corporation]

Returns the value of the interrupt to determine possible conflicts.
BIT [5:3] Parallel Port IRQ (read-only)
to Table 45B
BITS [2:0] Parallel Port DMA (read-only)
to Table 45C
ECR (Extended Control Register)
ADDRESS OFFSET = 402H
Mode = all
This register controls the extended ECP parallel port functions.
BITS 7,6,5
These bits are Read/Write and select the Mode.
BIT 4 nErrIntrEn
Read/Write (Valid only in ECP Mode)
1:
0:
BIT 3 dmaEn
Read/Write
1:
0:
BIT 2 serviceIntr
Read/Write
1:
0:
case dmaEn=1:
case dmaEn=0 direction=0:
case dmaEn=0 direction=1:
BIT 1 full
1:
0:
BIT 0 empty
Read only
1:
0:
SMSC DS – LPC47M14X
Disables the interrupt generated on the asserting edge of nFault.
Enables an interrupt pulse on the high to low edge of nFault. Note that an interrupt will be generated if nFault is
asserted (interrupting) and this bit is written from a 1 to a 0. This prevents interrupts from being lost in the time
between the read of the ecr and the write of the ecr.
Enables DMA (DMA starts when serviceIntr is 0).
Disables DMA unconditionally.
Disables DMA and all of the service interrupts.
Enables one of the following 3 cases of interrupts. Once one of the 3 service interrupts has occurred serviceIntr bit
shall be set to a 1 by hardware. It must be reset to 0 to re-enable the interrupts. Writing this bit to a 1 will not cause
an interrupt.
During DMA (this bit is set to a 1 when terminal count is reached).
This bit shall be set to 1 whenever there are writeIntrThreshold or more bytes free in the FIFO.
This bit shall be set to 1 whenever there are readIntrThreshold or more valid bytes to be read from the FIFO.
Read only
The FIFO cannot accept another byte or the FIFO is completely full.
The FIFO has at least 1 free byte.
The FIFO is completely empty.
The FIFO contains at least 1 byte of data.
Page 89
Rev. 03/19/2001