MAX6884ETP MAXIM [Maxim Integrated Products], MAX6884ETP Datasheet - Page 23

• Manufacturer Part Number: MAX6884ETP
• Description: EEPROM-Programmable, Hex Power-Supply Supervisory Circuits
• Manufacturer: MAXIM [Maxim Integrated Products]

The configuration registers can be directly modified by
the serial interface without modifying the EEPROM
after the power-up procedure terminates and the con-
figuration EEPROM data has been loaded into the con-
figuration register bank. Use the write byte or block
write protocols to write directly to the configuration reg-
isters. Changes to the configuration registers take
effect immediately and are lost upon power removal.
At device power-up, the register bank loads configura-
tion data from the EEPROM. Configuration data may
be directly altered in the register bank during applica-
tion development, allowing maximum flexibility.
Transfer the new configuration data, byte by byte, to
the configuration EEPROM with the write byte protocol.
The next device power-up or software reboot automati-
cally loads the new configuration. See
complete register map.
The configuration EEPROM addresses range from 80h to
97h. Write data to the configuration EEPROM to set up
the MAX6884/MAX6885 automatically upon power-up.
Data transfers from the configuration EEPROM to the
Table
REGISTER
ADDRESS
16h
11. User EEPROM Write Disable Bits
______________________________________________________________________________________
Configuration Register Bank
ADDRESS
MEMORY
EEPROM
96h
Configuration EEPROM
Power-Supply Supervisory Circuits
and EEPROM
Table
BIT RANGE
[1]
[0]
EEPROM-Programmable, Hex
12 for a
1 = User EEPROM Writes Disabled on RESET Assertion
0 = User EEPROM Writes Enabled on RESET Assertion
1 = User EEPROM Writes Disabled on UV/OV Assertion
0 = User EEPROM Writes Enabled on UV/OV Assertion
configuration registers when V CC exceeds UVLO during
power-up or after a software reboot. After V CC exceeds
UVLO, an internal 1MHz clock starts after a 5µs delay,
and data transfer begins. Data transfer disables access
to the configuration registers and EEPROM. The data
transfer from EEPROM to configuration registers takes
2.5ms maximum. Read configuration EEPROM and con-
figuration register data any time after power-up or soft-
ware reboot. Write commands to the configuration
EEPROM and configuration registers are allowed at any
time after power-up or software reboot unless the config-
uration lock bit is set (see
tion lock bit is set, all write access to EEPROM and
registers is disabled with the exception of the configura-
tion lock bit itself. The maximum cycle time to write a sin-
gle byte in EEPROM is 11ms (max).
The 512-bit user EEPROM addresses range from 40h to
7Fh (see
data, or other data in these registers. The maximum
cycle time to write a single byte is 11ms (max). Disable
writes to the user EEPROM during RESET or UV/OV
assertion by programming bit R16h[1] or R16h[0],
respectively (see
Figure
11). Store revision data, board revision
Table
DESCRIPTION
11).
Table
10). When the configura-
User EEPROM
23