SCA3000 VTI [VTI technologies], SCA3000 Datasheet - Page 8

• Manufacturer Part Number: SCA3000
• Description: 3-axis accelerometer
• Manufacturer: VTI [VTI technologies]

5
5.1 Land Pad Design
5.2 Solder Paste
VTI Technologies Oy
www.vti.fi
Pitch
0.80 mm
Printed Wiring Board (PWB) Level Guidelines
Two types of land patterns are used for surface mount packages:
1) Non-Solder Mask Defined Pads (NSMD)
2) Solder Mask Defined Pads (SMD).
NSMD pads have an opening which is larger than the pad itself, and SMD pads have a solder
mask opening that is smaller than the metal pad on PWB. NSMD is preferred since the copper
etching process has tighter process control compared to the solder mask process. The specific
PWB land pattern for the SCA3000 component is presented in figure 7.
Figure 7.
VTI's SCA3000 packages can be soldered on commonly used substrates, e.g. FR-4, ceramic etc.
The pad metallization should be solder wettable in order to assure good quality solder joints. For
fine pitch assembly, the quality of plating is important. Generally used circuit board finishes for fine
pitch SMD soldering are NiAu, OSP, Electroless-Ag and Electroless-Sn.
The SCA3000 package can be soldered with lead-free SAC (tin-silver-copper) solder. The SAC
solder paste composition should be near eutectic. The melting point of lead-free SAC solder can
vary between 217–221ºC, depending on the composition of solder alloy. In order to guarantee full
RoHS compatibility lead-free solder should be used for the soldering of VTI's SCA3000 component.
Also traditional eutectic SnPb solder can be used for soldering the SCA3000 packages if a lead-
free process is not required. With the eutectic SnPb solder, the melting point is 183°C.
A no-clean solder paste is recommended, since the SCA3000 package has very small stand off
and the effectiveness of cleaning process is therefore low. Ultrasonic agitation wash is not
allowed. The solder paste which is used must be suitable for printing it through the stencil aperture
dimensions. Type 3 paste is recommended (grain size 25-45mm).
7.25 mm
Recommended PWB pad layout for SCA3000 component.
Subject to changes
TN54
0.10 mm (extension of
PWB land towards
center of the package)
2.25 mm
0.976 mm
Component lead
(gray)
PWB land
(green)
SCA3000 Assembly Instructions
0.15 mm (extension of PWB land
towards outside of the package)
0.55 mm
0,025 mm (extension of
PWB land on both sides)
0.25 mm (minimum
recommended clearance)
Rev.C
8/15