ax88190 ASIX Electronics Corporation, ax88190 Datasheet - Page 16

no-image

ax88190

Manufacturer Part Number
ax88190
Description
Pcmcia 10/100m Fast Ethernet Mac Controller
Manufacturer
ASIX Electronics Corporation
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
ax88190AL
Manufacturer:
TOSHIBA
Quantity:
1 001
Part Number:
ax88190AL
Manufacturer:
ASLX
Quantity:
1 000
Part Number:
ax88190AL
Manufacturer:
ASLX
Quantity:
20 000
Part Number:
ax88190P
Manufacturer:
ASIX
Quantity:
1 122
Part Number:
ax88190P
Manufacturer:
ASIX
Quantity:
20 000
4.2 PCMCIA Function Configuration Register Set of MODEM
Tab - 13 PCMCIA Function Configuration Register Mapping of MODEM
4.2.1 Configuration Option Register of MODEM (MCOR) Offset 3E0H (Read/Write)
FIELD
5:0
REGISTER
7
6
MIOBASE0
MIOBASE1
AX88190
MCOR
MCSR
R/W/C
R/W
R/W
R/W
Software Reset
CONFIGURATION OPTION REGISTER
CONFIGURATION AND STATUS REGISTER
I/O BASED REGISTER 0
I/O BASED REGISTER 1
Level IRQ
Function Configuration Index
Assert this bit will reset the MODEM function of AX88190. Return a 0 to this bit will
leave the MODEM function of AX88190 in a post-reset state as same as that following a
hardware reset. The value of this bit is 0 at power-on.
This bit should be set to 1, the AX88190 always generates Level Mode Interrupt.
These six bits are used to indicate entry of the card configuration table locate in the CIS.
The default value is 0
.
On multifunction PC Card,
Bit 5, Bit4 : Reserved
Bit 3 : IREQ# route to STSCHG#
Bit 2 : Enable IREQ# Routing
Bit 1 : Enable Base and Limit Registers
Bit 0 : Enable Function
If bit 0 of MCOR is set to 0, this bit is ignored.
If both bit 0 and bit 2 of MCOR are set to 1 and this bit is set to 1, the MODEM will route
interrupt request to STSCHG# signal. If this bit is set to 0, the MODEM will generate
interrupt request via IREQ# line.
If bit 0 of MCOR is set to 0, this bit is ignored.
If bit 0 of MCOR is set to 1 and this bit is set to 1, the MODEM will generate interrupt
request via IREQ# signal. If this bit is set to 0, the MODEM will not generate interrupt
request via IREQ# line.
If bit 0 of MCOR is set to 0, this bit is ignored.
If bit 0 of MCOR is set to 1 and this bit is set to 1,only I/O addresses that are qualified
by the Base and Limit registers are passed to MODEM function. If this bit is set to 0,all
I/O addresses are passed to LAN function.
If this bit is set to 0, the MODEM function is disabled.
If this bit is set to 1, the MODEM function is enabled.
PCMCIA Fast Ethernet MAC Controller
NAME
16
DESCRIPTION
ASIX ELECTRONICS CORPORATION
OFFSET
3EAH
3ECH
3E0H
3E2H

Related parts for ax88190