CT2566-FP AEROFLEX [Aeroflex Circuit Technology], CT2566-FP Datasheet - Page 10

• Manufacturer Part Number: CT2566-FP
• Description: CT2566 MIL-STD-1553 to Microprocessor Interface Unit
• Manufacturer: AEROFLEX [Aeroflex Circuit Technology]

with a logic "1" (See Figure 9).
Aeroflex Circuit Technology
INTERRUPT MASK REGISTER
START/RESET REGISTER
This register is an eight bit read/write register used to enable the interrupt conditions. All interrupts are enabled
Only two bits of this write only register are used, as illustrated in Figure 10.
INTERRUPT
EOM
FORMAT ERROR/
STATUS SET
BC EOM
BIT
RESET
CONTROLLER START
BC EOM
FORMAT ERROR/STATUS SET
NOT USED
EOM
15
15
1
1
1
Figure 9 – Interrupt Mask Register
DEFINITION
End of Message. Set by CT2566 (during BC or RTU mode) every time a
1553 message is transferred (regardless of validity).
Set by CT2566 for these conditions:
Loop Test Failure: Last transmitted word did not match received word.
Message Error: Received message contained an address error, one of
eight 1553 status bits set, or 1553 specification violated (parity error,
Manchester error, etc).
Time-Out: Expected transmission was not received during allotted time
Status Set: Received status word contained status bit(s) set or address
error.
Bus Controller End of Message. Set by CT2566 (in BC mode) when all
messages have been transferred.
DEFINITION
Issued by the CPU to place the CT2566 in the power-on condition;
Configuration, and Interrupt Mask registers are reset to logic “0”.
Issued by the CPU (BC mode) to start message transmission. The CPU
must first load the number of messages to transfer (256, max) in the
message count location of RAM (area A or B). Value is loaded in 1’s
complement (load FFFE to transmit one message). In MT mode it is
used to begin reception of 1553 messages. Issued by CPU in MT mode
to enable monitor operation.
Figure 10 – Start/Reset Register
1
1
RESET
CONTROLLER START
1
NOT USED
1
10
NOT USED
4
3
2
SCDCT2566 REV B 8/10/99 Plainview NY [phone]
1
1
0
0