VCO600A278.528MHZ VECTRON [Vectron International, Inc], VCO600A278.528MHZ Datasheet - Page 3

• Manufacturer Part Number: VCO600A278.528MHZ
• Description: Voltage Controlled Saw Oscillator
• Manufacturer: VECTRON [Vectron International, Inc]

VCO-600A Voltage Controlled SAW Oscillator
1. By setting OD low, a test signal may be applied at CLKIN and fed through the VCO-600A to both the CLKOUT and CLKOUT to facilitate on board
testing. The test signal input applied at CLKIN may be either an ECL or sinewave input (up to 1Vpp, AC coupled). CLKIN is biased internally to
VBB (Vcc-1.3V)
2. An optional capacitor to ground can be placed on VBW to reduce the modulation bandwidth for narrow bandwidth phase-lock loop applications. The
modulation bandwidth will be approximately 1/(12000*C) Hz, where C is equal to the capacitance in Farads. If the optional capacitor is not utilized, VBW
becomes a no connect (NC) and the modulation bandwidth will be approximately equal to the nominal device frequency 1200.
3. By setting OD low, the outputs are disabled and CLKOUT is held Low while CLKOUT is held High. The threshold for OD is 1.4V above VEE. OD
should not be driven above mid supply and during normal operation, should be left floating (use with an open collector or 3-State gate for interfacing with
standard logic). If the OD feature is used during normal operation, then CLKIN should be tied through 10K
the CLKOUT outputs
Vectron International 267 Lowell Rd, Hudson NH 03051-4916
0.5 to 4.5V
-4.5 to -0.5V
19
21
4
19
21
4
2,12,27
10
Control Voltage
Output Disable
Test Clock In
Control Voltage
Output Disable
Test Clock In
V
V
EE
CC
Figure 1. PECL Operation
Figure 2. ECL Operation
Ground
Ground
VCO-600A
VCO-600A
V
1,3,9,11,13,14,15,16,18,20,22,24,26,28
V
1,3,9,11,13,14,15,16,18,20,22,24,26,28
CC
EE
3
Tel:1-88-VECTRON-1
+5 V
2,12,27
-5 V
10
OUT
OUT
OUT
OUT
+3V, 50ohms
17
-2V, 50ohms
17
e-mail [e-mail]
to GND to avoid any possibility of chatter on
Optional
Capacitor
Reduces
Bandwidth
Optional
Capacitor
Reduces
Bandwidth
23
25
23
25