ps-4sr Omron Corporation, ps-4sr Datasheet - Page 2

• Manufacturer Part Number: ps-4sr
• Description: Electrode Holder
• Manufacturer: Omron Corporation

■ PS-@S(R) Electrode Holder Accessories (Order Separately)
Note: If the F03-11 and F03-12 are used together, the screws and bolts that are provided with the F03-11 cannot be used.
■ PS-31 Electrode Holder Accessories (Order Separately)
■ Accessories Required for Connecting the PS-@S(R) and Electrodes
Electrodes Shorter
than 1 m
The following items are required
for each pole.
• 1 × F03-01 Electrode
• 1 × F03-03 Lock Nut
The Electrode can be cut
anywhere based on the control
level.
Note: 1. The spring washer comes with the lock nut.
Note: This Bushing is not waterproof.
Use this Cover for PS-series Electrode
Holders with Mounting Frames (upper
one in the following illustration), This
Cover can also be used when installing
the BF-series Electrode Holders
outdoors. Since this Cover is not
water-proof, water or dust may enter
through the wire hole (lower one below).
Applicable Electrode Holders:
BF-3, BF-4, BF-5, PS-3S(R), PS-4S(R),
PS-5S(R)
60
(Order Separately)
F03-31 Dust-proof Rubber Bushing
2. Refer to F03-
6 dia. (inner)
120 dia.
F03-11 Protective Cover
Protective Cover
F03-11
Electrode Holder
PS-@S
Spring Clamp
F03-12
Weight: approx. 65g
Operating temp.: −10°C to 70°C
75
@
Material: Silicon rubber
for details on Electrodes, Connecting Nuts, Lock Nuts, and Separators.
32 dia.
Electrode
Spring washer (See note 1.)
Lock nut
Used to clamp an Electrode Holder
with ease, as shown in the illustrations,
when the Electrode Holder is applied
to a tank without a coupling.
Squeeze the mounting frame into
the Holder as shown below.
Applicable Electrode Holders:
PS-3S(R), PS-4S(R), PS-5S
Four, M5 x 25
mounting
screws
Electrode
10
F03-12 Spring Clamp
112 dia.
96
Operating temp: −10°C to 70°C
Weight: approx. 80g
Electrode Longer
than 1 m
The following items are required for every
additional meter of electrode for each pole.
• 1 × F03-01 Electrode
• 1 × F03-02 Connecting Nut
• 2 × F03-03 Lock Nuts
Use F03-14 1P, 3P, and 5P Separators to
prevent the electrodes from touching each
another.
Firmly secure the F03-12 Spring Clamp to
the F03-13 Mounting Frame with M5 x 25
screws and embed it into the concrete
production water tank. Cut the F03-13 to
match the depth of the concrete.
F03-13 Mounting Frame for installing in
100
Commonly used with
Mounting Frame
Mounting Frame
embedded into
concrete
80
60
115 dia.
72 dia.
82 dia.
96
concrete
PS-@S(R)/-31
Weight: approx. 120g
Electrode
70
Lock nut
Electrode
Separator (1-pole)
Spring washer
Connecting nut
2