hb28d032bp2 Renesas Electronics Corporation., hb28d032bp2 Datasheet - Page 23

• Manufacturer Part Number: hb28d032bp2
• Description: Mobile Embedded Flash With Multimediacard-tm Interface 16 Mbyte/32 Mbyte
• Manufacturer: Renesas Electronics Corporation.

MultiMediaCard Communication
All communication between host and cards is controlled by the host (master). The host sends commands
and, depending on the command, receives a corresponding response from the selected card. In this chapter
the commands to control these Hitachi Mobile Embedded Flashes, the card responses and the contents of
the status and error field included in the responses, are defined.
Memory Array Partitioning
The basic unit of data transfer to/from these Hitachi Mobile Embedded Flashes is one byte. All data
transfer operations which require a block size always define block lengths as integer multiples of bytes.
Some special functions need other partition granularity. For block-oriented commands, the following
definition is used:
For devices which have erasable memory cells, special erase commands are defined. The granularity of the
erasable units is:
For devices which include a write protection:
Each erasable unit (erase group and sector) has a special “tag” bit. This bit may be set or cleared by special
commands to tag the unit. All tagged units will be erased in parallel by one erase command following a
number of tag commands. All tag bits are cleared by each command except a tag or untag command.
Therefore, immediately after a sequence of tag commands an erase command has to be sent by the host.
Commands others than tagging or erasing abort a tag-erase cycle irregularly.
Block: is the unit which is related to the block-oriented read and write commands. Its size is the
number of bytes which will be transferred when one block command is sent by the host. The size of a
block is either programmable or fixed. The information about allowed block sizes and the
programmability is stored in the CSD.
Sector: is the unit which is related to the tagged sector commands (CMD32 to CMD34). In these
Hitachi Mobile Embedded Flashes, this size is same as the WRITE_BLK_LEN in CSD.
Erase Group: is the smallest number of consecutive write blocks, which can be addressed for erased.
The size of the Erase Group is card specific and stored in the CSD.
WP-Group: is the minimal unit which may have individual write protection. Its size is the number of
erase groups which will be write protected by one bit. The size of a WP-group is fixed for each device.
The information about the size is stored in the CSD.
HB28E016/D032BP2
23