s5u1c88112d Epson Electronics America, Inc., s5u1c88112d Datasheet - Page 37

• Manufacturer Part Number: s5u1c88112d
• Description: Cmos 8-bit Single Chip Microcomputer
• Manufacturer: Epson Electronics America, Inc.

3.3.9 Error message
In the packing operation, program data HEX file and function option data file are checked; in the unpack-
ing operation, the packed file is checked. If there is any abnormal format, the message below is displayed.
The mdc88112 error message lists are indicated below.
*
S5U1C88112D MANUAL
(DEVELOPMENT SOFTWARE TOOL FOR S1C88112)
MESSAGE : SEPARATED DATA WITH 12K AS MASK DATA
HEX DATA ERROR : NOT S RECORD.
HEX DATA ERROR : DATA LENGTH.(NOT 24H)
HEX DATA ERROR : ADDRESS.
HEX DATA ERROR : TOO MANY DATA IN ONE LINE.
HEX DATA ERROR : CHECK SUM.
HEX DATA ERROR : DUPLICATE.
HEX DATA ERROR : NO 00H ADDRESS
HEX DATA ERROR : NO FILLED FILE WITH FFH
OPTION DATA ERROR : START MARK.
OPTION DATA ERROR : OPTION NUMBER.
OPTION DATA ERROR : SELECT NUMBER.
OPTION DATA ERROR : END MARK.
<file name> FILE IS NOT FOUND.
PACK FILE NAME (file name) ERROR.
PACKED FILE NAME (file name) ERROR.
Directory Full
Disk Write Error
\ sometimes appears as ¥, depending on the personal computer being used.
Error message
Error message
Error message
Error message
Message
Table 3.3.9.2 Function option data error message list
Table 3.3.9.1 Program data error message list
Table 3.3.9.4 System error message list
Table 3.3.9.3 File error message list
3 DETAILED EXPLANATION OF TOOLS (Mask Data Checker mdc88112)
EPSON
When data in ".psa" exceeds 12K bytes (built-
in ROM capacity of the S1C88112), it packs
the 0000H to 2FFFH data as mask data.
There is no S record.
The data length of 1 line is not 24H.
The address length is not 3 bytes.
There are too many data in 1 line.
The checksum is not correct.
There is duplicate definition of data in the
same address.
There is no data in the physical address 00H.
The data of the unused area are not FFH.
The start mark is not "\OPTION". (during
unpacking) *
The option number is not correct.
The option selection number is not correct.
The end mark is not "\\END" (packing) or
"\END" (unpacking). *
The file is not found or the file number set in
CONFIG.SYS is less.
The packed input format for the file name is
wrong.
The unpacked input format for the file name is
wrong.
The directory is full.
Writing on the disk is failed.
Explanation
Explanation
Explanation
Explanation
Explanation
31