ak4560a AKM Semiconductor, Inc., ak4560a Datasheet - Page 41

• Manufacturer Part Number: ak4560a
• Description: 16bit Codec With Alc And Mic/hp/spk-amps
• Manufacturer: AKM Semiconductor, Inc.

ASAHI KASEI
2. ALC1 Recovery Operation
The ALC1 recovery operation waits until a time of setting WTM1-0 bits after completing the ALC1 limiter. If the input
signal does not exceed “LMTH – 2dB”, the ALC1 recovery operation is done. The IPGA value increases automatically by
this operation up to the set reference level (REF6-0 bits). Then the IPGA value is set for L/R commonly. The ALC1
recovery operation is done at a period set by WTM1-0 bits.
When L/R channels are detected by zero crossing operation during WTM1-0, the ALC1 recovery operation waits until
WTM1-0 period and the next recovery operation is done.
During the ALC1 recovery operation, when either input signal level of Lch or Rch exceeds the ALC1 limiter detection
level (LNTH), the ALC1 recovery operation changes into the ALC1 limiter operation immediately
In case of “(Recovery waiting counter reset level) Input Signal < Limiter detection level” during the ALC1 recovery
operation, the waiting timer of ALC1 recovery operation is reset. Therefore, in case of “(Recovery waiting counter reset
level) > Input Signal”, the waiting timer of ALC1 recovery operation starts.
(1). When the input signal is below the ALC1 recovery waiting counter reset level, the ALC1 recovery operation waits the
(2). The IPGA value is changed by the zero crossing operation in ALC1 recovery operation, but the next counter of the
Other:
When a channel of one side enters the limiter operation during the waiting zero crossing, the present ALC1 recovery
operation stops, according as the small value of IPGA (a channel of waiting zero crossing), the ALC1 limiter operation is
done.
When both channels are waiting for the next ALC1 recovery operation, the ALC1 limiter operation is done from the IPGA
value of a point in time.
During the ALC1 operation, the value of writing in IPGA6-0 bits is ignored.
MS0028-E-00
WTM counter starts
time set by WTM1-0 bits. If the input signal does not exceed the ALC1 limiter detection level or the ALC1 recovery
waiting counter reset level, the ALC1 recovery operation is done only once.
ALC1 recovery waiting timer is also starting.
(2)
Figure 32. The transition from the limiter operation to the recovery operation
During recovery counter reset
WTM counter starts
- 41 -
ZTM counter starts
WTM counter starts
(1)
ZTM counter starts
WTM counter starts
(2)
Limiter detection level (LMTH)
Recovery waiting counter
reset level (LMTH)
Zero crossing detect
(2)
[AK4560A]
2000/05