gs2988 Gennum Corporation, gs2988 Datasheet - Page 13

• Manufacturer Part Number: gs2988
• Description: Gs2988 Dual-slew-rate, Cable Driver With 3gb/s Capability
• Manufacturer: Gennum Corporation

This formula should be considered as a starting point, and actual swing values may vary
based on layout. Also, for large output swings (>1040mV), smaller Rset values may be
required in order to achieve the desired output swing level at HD and 3G data rates.
Table 4-5: Typical RSET Values
4.7 Output Return Loss Measurement
The GS2988 has a feature which allows users to measure ORL reliably while the device
is still powered. The device can be put into a BALANCE mode which prevents the
outputs from toggling while the device is powered on, allowing the ORL to be measured
while the device is still powered.
When EQ_EN is LOW while SD/HD is HIGH, the device goes into BALANCE mode. This
mode is used during ORL measurement, disabling the AC signal path of the device
without powering it down. When in BALANCE mode, the device produces equal
pull-down currents in both differential shoulders of the serial data differential output,
effectively stopping the output at the output common mode voltage level. Gennum
recommends using BALANCE mode when measuring ORL with 2.5V termination
voltage.
GS2988 Dual-Slew-Rate, Cable Driver with 3Gb/s
Capability
Data Sheet
52131 - 1
*NOTE: In order to generate output swings greater than 1040mV, VCC_TERM must be
Output Swing (mV)
February 2010
1800*
800
500
connected to a 5V supply.
RSET (Ω)
1210
332
750
13 of 18