lt3990 Linear Technology Corporation, lt3990 Datasheet - Page 8

• Manufacturer Part Number: lt3990
• Description: 60v, 350ma Step-down Regulator With 2.5?a Quiescent Current And Integrated Diodes
• Manufacturer: Linear Technology Corporation

LT3990
operaTion
The LT3990 is a constant frequency, current mode step-
down regulator. An oscillator, with frequency set by RT,
sets an RS flip-flop, turning on the internal power switch.
An amplifier and comparator monitor the current flowing
between the V
this current reaches a level determined by the voltage at
V
output voltage through an external resistor divider tied to
the FB pin and servos the V
output increases, more current is delivered to the output;
if it decreases, less current is delivered.
Another comparator monitors the current flowing through
the catch diode and reduces the operating frequency when
the current exceeds the 440mA bottom current limit. This
foldback in frequency helps to control the output current
in fault conditions such as a shorted output with high
input voltage. Maximum deliverable current to the output
is therefore limited by both switch current limit and catch
diode current limit.
An internal regulator provides power to the control cir-
cuitry. The bias regulator normally draws power from
the V
voltage higher than 3.2V, bias power will be drawn from
the external source (typically the regulated output voltage).
This improves efficiency.

C
(see Block Diagram). An error amplifier measures the
IN
pin, but if the BD pin is connected to an external
IN
and SW pins, turning the switch off when
C
node. If the error amplifier’s
If the EN/UVLO pin is low, the LT3990 is shut down and
draws 0.7µA from the input. When the EN/UVLO pin exceeds
1.21V, the switching regulator will become active.
The switch driver operates from either V
BOOST pin. An external capacitor is used to generate a
voltage at the BOOST pin that is higher than the input
supply. This allows the driver to fully saturate the internal
bipolar NPN power switch for efficient operation.
To further optimize efficiency, the LT3990 automatically
switches to Burst Mode operation in light load situations.
Between bursts, all circuitry associated with controlling
the output switch is shut down reducing the input supply
current to 1.7µA.
The LT3990 contains a power good comparator which
trips when the FB pin is at 90% of its regulated value. The
PG output is an open-drain transistor that is off when the
output is in regulation, allowing an external resistor to pull
the PG pin high. Power good is valid when the LT3990 is
enabled and V
IN
is above 4.2V.
IN
or from the
3990p