lh28f320bfhe-pbtlez Sharp Microelectronics of the Americas, lh28f320bfhe-pbtlez Datasheet - Page 14

• Manufacturer Part Number: lh28f320bfhe-pbtlez
• Description: Flash Memory 32mbit 2mbitx16
• Manufacturer: Sharp Microelectronics of the Americas

6. Either 40H or 10H are recognized by the CUI (Command User Interface) as the program setup.
7. Following the third bus cycle, input the program sequential address and write data of "N" times. Finally, input the any
8. If the program operation in one partition is suspended and the erase operation in other partition is also suspended, the
9. Full chip erase and OTP program operations can not be suspended. The OTP Program command can not be accepted
10. Following the Clear Block Lock Bit command, block which is not locked-down is unlocked when WP#/ACC is V
11. Commands other than those shown above are reserved by SHARP for future device implementations and should not be
valid address within the target block to be programmed and the confirm command (D0H). Refer to Appendix of
LH28F320BF series for details.
suspended program operation should be resumed first, and then the suspended erase operation should be resumed next.
while the block erase operation is being suspended.
When WP#/ACC is V
configuration.
used.
IH
, lock-down bit is disabled and the selected block is unlocked regardless of lock-down
LHF32FEZ
Rev. 2.44
11
IL
.